Related Experiment Video
Updated: Feb 11, 2026

Murine Full-thickness Skin Transplantation
Published on: January 2, 2017
One-stage Pelnac Reconstruction in Full-thickness Skin Defects with Bone or Tendon Exposure
Xianghong Lou1, Hang Xue1, Gongchi Li1
1Department of Hand Surgery, Union Hospital, Tongji Medical College, Huazhong University of Science & Technology, Hubei, PR China; and Wound Repair Section, Liyuan Hospital, Tongji Medical College, Huazhong University of Science & Technology, Hubei, PR China.
Abstract:
Dermal regeneration template, such as Integra and Pelnac, was originally designed for treating large area burn injury by inducing regeneration of dermis. To date, it has been widely applied in various acute and chronic wound sites. The present study demonstrated that application of artificial dermis alone induced 1-stage wound healing for wounds with bone or tendon exposure that should usually be repaired by flap surgery. Eight patients who presented with skin defects with bone and/or tendon exposure were treated by 1-stage Pelnac approach. All wounds healed within 20 weeks without skin graft or flap surgery. The wound area was reconstructed by nearly normal skin structure and linear scar. In the case of scalp defect, evidence of hair follicle cell migration and regeneration during healing process was observed. Thereby, the 1-stage Pelnac reconstitution can be considered as a novel method for inducing regrowth of epidermis and hair follicles to cure large full-thickness skin defect with bone and tendon exposure in 1 stage.
Related Concept Videos
Lumber Defects
Shakes are minor fractures that run along or across the wood's annual rings, while wane is...
Stages of Infection
Stages of Sleep
Before sleep begins, in wakefulness, the brain exhibits primarily beta waves, which are high in frequency and low in amplitude, indicating alertness...
Stages of General Anesthesia
Reconstruction of Signal using Interpolation
Design Example: Deciding Thickness of Lubricating Fluid in a Shaft
To calculate the required thickness of the lubricant layer, the tangential velocity at the shaft's surface must first be determined. This velocity is calculated by converting the rotational speed to angular velocity...

