Related Experiment Video
Updated: Feb 11, 2026

Preparation of Chitosan-based Injectable Hydrogels and Its Application in 3D Cell Culture
Published on: September 29, 2017
[Preparation and Characterization of Chitosan-Poloxamer-based Antibacterial Hydrogel Containing Silver Nanoparticles]
Abstract:
In order to solve the problem of high cytotoxicity in vitro of nano-silver antibacterial gel,and the problem of large nano-silver particle size and size distribution,this study prepared nano-silver antibacterial gel with better biocompatibility and good antibacterial effect by using physical cross-linking method and using poloxamer as dispersant when prepared nano-silver.In this study,nano-silver was prepared by photo-initiator method and by adding poloxamer as a dispersant,and then UV-visible absorption spectrum test and scanning electron microscopy(SEM)test were carried out using prepared nano-silver mixture and particles after drying respectively.The gel was prepared through adjusting its pH value by using sodium bicarbonate,and then pH value test,SEM test for cross-section of gel,swelling ratio test,viscosity test,inhibition zone test and in vitro cytotoxicity test were carried out.The test results showed that the maximum absorption wavelength of prepared nano-silver,using poloxamer as dispersant and ultra-pure water as solvent,was 414 nm,and the average nano-silver size was about 60 nm.The prepared nano-silver using poloxamer as dispersant had smaller particle diameter and narrower particle size distribution than those using PVP as dispersant.Similarly,the prepared nano-silver using ultra-pure water as solvent also had smaller particle diameter and narrower particle size distribution than those using distilled water as solvent.The pH value of the prepared gel was between 5.8~6.1.The dried gel section had many holes.The water absorption of gel was fine and the viscosity of gel was fit to coat on the gauze.In addition,the prepared gel with nano-silver had greater ability to inhibit Escherichia coli and Staphyloccocus aureus at the concentrations of 24,18 and 12μg/mL.And the biocompatibility of the prepared gel with nano-silver was good when the concentration below 24μg/mL.Based on the above features,the nano-silver antibacterial gel could be used in the treatment of burn or other wounds.
Related Concept Videos
Preparation of Epoxides
Epoxides result from alkene oxidation, which can be achieved by a) air, b) peroxy acids, c) hypochlorous acids, and d) halohydrin cyclization.
Epoxidation with Peroxy Acids
Epoxidation of alkenes via oxidation with peroxy acids involves the conversion of a carbon–carbon double bond to an epoxide using the oxidizing agent meta-chloroperoxybenzoic acid, commonly known as MCPBA. Since the O–O bond of peroxy acids is very weak, the addition of electrophilic oxygen of peroxy acids to...
Preparation of Amides
The DCC-promoted synthesis of amides begins with the protonation of DCC by carboxylic acid. The protonation makes it a better acceptor. Next, the addition of carboxylate to the protonated carbodiimide gives a reactive acylating agent.
Subsequently, the amine acts as a nucleophile that attacks the acylating agent to form a tetrahedral intermediate. In the...
Preparation of Nitriles
Weak Base Solutions
Preparation and Reactions of Thiols
Preparation of Acid Anhydrides
The carboxylate ion acts as a nucleophile that attacks the carbonyl carbon of the acid chloride to form a tetrahedral intermediate. Subsequently, the re-formation of the carbonyl group with the loss of the chloride ion as a leaving group leads to the formation of an acid...

