Deviation from equilibrium conditions in molecular dynamic simulations of homogeneous nucleation

Roope Halonen1, Evgeni Zapadinsky1, Hanna Vehkamäki1

  • 1Institute for Atmospheric and Earth System Research/Physics, Faculty of Science, University of Helsinki, Helsinki, Finland.

Related Concept Videos

Dynamic Equilibrium02:20

Dynamic Equilibrium

A reversible chemical reaction represents a chemical process that proceeds in both forward (left to right) and reverse (right to left) directions. When the rates of the forward and reverse reactions are equal, the concentrations of the reactant and product species remain constant over time and the system is at equilibrium. A special double arrow is used to emphasize the reversible nature of the reaction. The relative concentrations of reactants and products in equilibrium systems vary greatly;...
63.3K
Conditions of Equilibrium01:28

Conditions of Equilibrium

Equilibrium refers to a state where a rigid body is not subjected to any translational or rotational motion. This state is achieved when the force and couple acting on a rigid body equal zero. When the system of external forces results in a net effect equivalent to zero, the rigid body is considered to be in equilibrium.
Internal forces are not considered for conditions of equilibrium because they occur in equal and opposite pairs within the body, effectively canceling each other. As a result,...
2.2K
Equilibrium Conditions for a Particle01:23

Equilibrium Conditions for a Particle

When an object is in equilibrium, it is either at rest or moving with a constant velocity. There are two types of equilibrium: static and dynamic. Static equilibrium occurs when an object is at rest, while dynamic equilibrium occurs when an object is moving with a constant velocity. In both cases, there must be a balance of forces acting on the object.
To understand the concept of equilibrium, let us first consider the forces acting on an object. When different forces act on an object, they can...
2.3K
Solution Equilibrium and Saturation01:59

Solution Equilibrium and Saturation

Imagine adding a small amount of sugar to a glass of water, stirring until all the sugar has dissolved, and then adding a bit more. You can repeat this process until the sugar concentration of the solution reaches its natural limit, a limit determined primarily by the relative strengths of the solute-solute, solute-solvent, and solvent-solvent attractive forces. You can be certain that you have reached this limit because, no matter how long you stir the solution, undissolved sugar remains. The...
22.1K
Homogeneous Equilibria for Gaseous Reactions02:15

Homogeneous Equilibria for Gaseous Reactions

Homogeneous Equilibria for Gaseous Reactions
For gas-phase reactions, the equilibrium constant may be expressed in terms of either the molar concentrations (Kc) or partial pressures (Kp) of the reactants and products. A relation between these two K values may be simply derived from the ideal gas equation and the definition of molarity. According to the ideal gas equation:
29.4K
Free Energy and Equilibrium02:56

Free Energy and Equilibrium

The free energy change for a process may be viewed as a measure of its driving force. A negative value for ΔG represents a driving force for the process in the forward direction, while a positive value represents a driving force for the process in the reverse direction. When ΔGrxn is zero, the forward and reverse driving forces are equal, and the process occurs in both directions at the same rate (the system is at equilibrium).
Recall that Q is the numerical value of the mass action...
27.3K