Cervical Myelopathy after High-voltage Electrical Burn of the Head: Report of an Unusual Case

Shri Ram Sharma1, Masaraf Hussain1, Hibo Hibong1

  • 1Department of Neurology, North Eastern Indira Gandhi Regional Institute of Medical Sciences, Shillong, Meghalaya, India.

Related Concept Videos

Unusual Results01:16

Unusual Results

Unusual results are those that have a very low chance of occurring. Unusual results can be identified using probabilities and the range rule of thumb. In problems involving probability, unusual results can be observed in 2 instances – an unusually high number of successes or an unusually low number of successes.
According to the range rule of thumb, any value above or below two standard deviations, 2σ  from the mean, μ  is considered unusual.
Maximum unusual value =...
3.9K
z Scores and Unusual Values01:07

z Scores and Unusual Values

The z score is one of the three measures of relative standing. It describes the location of a value in a dataset relative to the mean. z scores are obtained after the standardization of the values in a dataset. The z score for the mean is 0.
 This score indicates how far a value is from the mean in terms of standard deviation. For example, if a data value has a z score of +1, the researcher can infer that the particular data value is one standard deviation above the mean. If another data...
11.1K
Burn Injuries01:22

Burn Injuries

Burn injuries occur when the skin and underlying tissues are damaged due to exposure to heat, electricity, chemicals, radiation, or friction. They can vary in severity, from minor superficial burns to severe deep burns that can be life-threatening.
The damage results in the death of skin cells, which can lead to a massive loss of fluid. Dehydration, electrolyte imbalance, and renal and circulatory failure follow, which can be fatal. Burn patients are treated with intravenous fluids to offset...
4.6K
Voltage01:13

Voltage

The movement of electrons in a conductor requires some form of energy or work, usually provided by an external force, like a battery. This force is called the electromotive force or voltage. The voltage between two points, referred to as points "a" and "b," in an electric circuit is the energy (or work) needed to move a unit charge from point "a" to point "b," and this relationship is expressed mathematically as
4.3K
Multiple Voltage Sources01:25

Multiple Voltage Sources

Generally, a single battery is not enough to power some devices. In such cases, batteries can be combined in two ways: in series or in parallel.
In series, the positive terminal of one battery is connected to the negative terminal of another battery. Hence, the voltage of each battery is added to give the net voltage, which is increased because each battery boosts the electrons that enter it. The same current flows through each battery because they are connected in series.
Batteries are...
1.8K
Voltage Dividers01:14

Voltage Dividers

In electrical circuits, resistors can be connected in series, sequentially linked one after the other. In a series configuration, the same current flows through each resistor. Ohm's law is a fundamental principle to understand the behavior of resistors in series. It expresses the voltage across these resistors in terms of the current and resistance.
Kirchhoff's voltage law implies that the sum of the voltages across the resistors in series equals the source voltage. This means that the current...
1.4K