Microtrauma in the lumbar spine: a cause of low back pain

Excessive mechanical stress on the intervertebral disc may be one of the causes of low back pain. Most studies testing this thesis, however, have been based on quantification of the mechanical response of functional units at failure. Typically, radiography is used to demonstrate trauma to the vertebral body at the failure load. The description of failure and radiographic demonstration of damage are meaningful in specifying the tolerance limits of the structure. It is important, however, to understand the sequence underlying the initiation of injury, which may occur at subfailure physiological loads. In this study, we identified the initiation of injury to the lumbar spine by subjecting functional units to axial compressive loads using the mechanical response as a basis. Because conventional radiography failed to detect trauma at this level, advanced sectioning techniques were used. The initiation of injury (microtrauma) is defined as the point on the load-deflection curve where the structure exhibits a decreasing level of resistance for the first time before reaching its ultimate load-carrying capacity. The load deflection curve on this basis was classified into the ambient or preload phase, physiological loading phase, traumatic phase, and post-traumatic phase. Structures loaded to the end of the physiological loading phase did not exhibit any yielding or microtrauma. Injury in the form of microfractures of the endplate not detected on radiography, however, was observed under cryomicrotomy for structures loaded into the traumatic loading phase.