Detection of perimacular red dots and blots when screening for diabetic retinopathy: Refer or not refer?

Anatolie Baltatescu1, Elio Striglia1, Marina Trento1

  • 11 Diabetic Retinopathy Centre, Department of Medical Sciences, University of Turin, Turin, Italy.

Abstract

Related Concept Videos

Inertial Frames of Reference01:03

Inertial Frames of Reference

Newton’s first law is usually considered to be a statement about reference frames. It provides a method for identifying a special type of reference frame: the inertial reference frame. In principle, we can make the net force on a body zero. If its velocity relative to a given frame is constant, then that frame is said to be inertial. So, by definition, an inertial reference frame is a reference frame where Newton's first law holds valid. Newton's first law applies to objects with...
8.9K
Non-inertial Frames of Reference01:27

Non-inertial Frames of Reference

A reference frame accelerating or decelerating relative to an inertial frame is a non-inertial frame. To help understand this, consider what taking off in an airplane, turning a corner in a car, riding a merry-go-round, and the circular motion of a tropical cyclone all have in common. All these systems are accelerating, decelerating, or rotating relative to the Earth; hence, they all are non-inertial frames. All these systems exhibit inertial forces, which merely seem to arise from motion,...
7.2K
Chemical Shift: Internal References and Solvent Effects01:17

Chemical Shift: Internal References and Solvent Effects

In an NMR sample, precise measurement of the absolute absorption frequencies of nuclei is difficult. A standard internal reference compound is added, and the frequency difference between the reference signal and sample signals is measured.
The internal reference compound generally used in NMR spectroscopy is tetramethylsilane (TMS). TMS is preferred because it is chemically inert, soluble in NMR solvents, and easily removable. Also, the highly shielded methyl protons in TMS yield an intense...
1.4K
The Dot Product01:26

The Dot Product

Measuring how one directional quantity affects another along a specific path involves comparing their orientation and strength. When two such quantities are represented using direction and amount, a numerical result is computed to show how much one acts along the path of the other. This result comes from a rule combining both inputs' horizontal and vertical parts and adding the results.This calculation gives a single value that grows larger when both inputs point in similar directions and...
266
Dot Product01:29

Dot Product

The dot product is an essential concept in mathematics and physics.
In engineering, the dot product of any two vectors is the product of the magnitudes of the vectors and the cosine of the angle between them. It is denoted by a dot symbol between the two vectors.
Consider a vehicle pulling an object along the ground using a rope. If the rope makes an angle with the horizontal axis, the work done can be calculated using the dot product of the force applied and the object's displacement.
The dot...
1.0K