Related Experiment Video
Updated: Feb 10, 2026

Interfacial Molecular-level Structures of Polymers and Biomacromolecules Revealed via Sum Frequency Generation Vibrational Spectroscopy
Published on: August 13, 2019
Combined Sum Frequency Generation and Thin Liquid Film Study of the Specific Effect of Monovalent Cations on the
Afshin Asadzadeh Shahir1, Khristo Khristov2, Khoi Tan Nguyen1,3
1School of Chemical Engineering , The University of Queensland , Brisbane , Queensland 4072 , Australia.
Abstract:
Some salts have been recently shown to decrease the sum frequency generation (SFG) intensity of the hydrogen-bonded water molecules, but a quantitative explanation is still awaited. Here, we report a similar trend for the chloride salts of monovalent cations, that is, LiCl, NaCl, and CsCl, at low concentrations. Specifically, we revealed not only the specific adsorption of cations at the water surface but also the concentration-dependent effect of ions on the SFG response of the interfacial water molecules. Our thin-film pressure balance (TFPB) measurements (stabilized by 10 mM of methyl isobutyl carbinol) enabled the determination of the surface potential that governs the surface electric field affecting interfacial water dipoles. The use of the special alcohol also enabled us to identify a remarkable specific screening effect of cations on the surface potential. We explained the concentration dependency by considering the direct ion-water interactions and water reorientation under the influence of surface electric field as the two main contributors to the overall SFG signal of the hydrogen-bonded water molecules. Although the former was dominant only at the low-concentration range, the effect of the latter intensified with increasing salt concentration, leading to the recovery of the band intensity at medium concentrations. We discussed the likelihood of a correlation between the effect of ions on reorientation dynamics of water molecules and the broad-band intensity drop in the SFG spectra of salt solutions. We proposed a mechanism for the cation-specific effect through the formation of an ionic capacitance at the solution surface. It explains how cations could impart the ion specificity while they are traditionally believed to be repelled from the interfacial region. The electrical potential of this capacitance varies with the charge separation and ion density at the interface. The charge separation being controlled by the polarizability difference between anions and cations was identified using the SFG response of the interfacial water molecules as an indirect probe. The ion density being affected by the absolute polarizability of ions was tracked through the measurement of the surface potentials and Debye-Hückel lengths using the TFPB technique.
Related Concept Videos
Aromatic Hydrocarbon Cations: Structural Overview
Removing one hydrogen from the intervening CH2 group...
Sums of Power
Wilcoxon Rank-Sum Test
Water and Mineral Acquisition
States of Water
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
Sum and Difference OpAmps
A summing amplifier, or an adder, utilizes an op-amp to merge multiple input signals into a single output signal. When audio signals are introduced into its input channels, the input resistors initiate currents that traverse feedback resistors, resulting in an output voltage. Applying Kirchhoff's current...

