Black plastics: Linear and circular economies, hazardous additives and marine pollution

Andrew Turner1

  • 1School of Geography, Earth and Environmental Sciences, Plymouth University, Drake Circus, Plymouth PL4 8AA, UK.

Related Concept Videos

Plastic Deformation in Circular Shafts01:20

Plastic Deformation in Circular Shafts

When materials are subjected to forces that surpass their yield strength, they undergo a process known as plastic deformation. This results in a permanent alteration or strain in their structure. This concept can be specifically applied to circular shafts, where the deformation leads to a change in its shape. The precise evaluation of this plastic deformation requires understanding the stress distribution within the circular shaft, which is achieved by calculating the maximum shearing stress in...
486
Circular Shaft - Stresses in Linear Range01:13

Circular Shaft - Stresses in Linear Range

Consider a scenario where a circular shaft is subject to torque that remains within the boundaries of Hooke's Law, avoiding any permanent deformation. So, the formula for shearing strain is revisited. This formula is multiplied by the modulus of rigidity, and then Hooke's Law for the shearing stress and strain is applied. As a result, the equation for shearing stress in a shaft can be derived.
743
Hazard Rate01:11

Hazard Rate

The hazard rate, also known as the hazard function or failure rate, is a statistical measure used to describe the instantaneous rate at which an event occurs, given that the event has not yet happened. From a probabilistic perspective, it represents the likelihood that a subject will experience the event in a very small time interval, conditional on surviving up to the beginning of that interval. In terms of frequency, the hazard rate can be viewed as the ratio of the number of events to the...
440
Hazard Ratio01:12

Hazard Ratio

The hazard ratio (HR) is a widely used measure in clinical trials to compare the risk of events, such as death or disease recurrence, between two groups over time. It reflects the ratio of hazard rates—the instantaneous risk of the event occurring—between a treatment group and a control group. This measure provides valuable insights into the relative effectiveness of a treatment by assessing how the risk of an event differs between the two groups.
For example, in a clinical trial...
624
Conjugate Addition (1,4-Addition) vs Direct Addition (1,2-Addition)01:27

Conjugate Addition (1,4-Addition) vs Direct Addition (1,2-Addition)

α,β-Unsaturated carbonyl compounds with two electrophilic sites, the carbonyl carbon, and the β carbon, are susceptible to nucleophilic attack via two modes: conjugate or 1,4-addition and direct or 1,2-addition.
Conjugate addition results in a thermodynamically stable product. The reaction retains the stronger C=O bond at the expense of the weaker C=C π bond. The process is slow as the β carbon is less electrophilic than the carbonyl carbon.
Direct addition products are...
4.4K
Plasticity00:58

Plasticity

Plasticity is the property where an object loses its elasticity and undergoes irreversible deformation, even after the deformation forces are eliminated. If a material deforms irreversibly without increasing stress or load, then this is called ideal plasticity. For example, when a force is applied to an aluminum rod, it changes its shape, but it does not return to its original shape once the force is removed. Plastic deformation or ductility is thus a permanent deformation or change in the...
3.1K