Related Experiment Video

Updated: Jul 29, 2026

Bioindication Testing of Stream Environment Suitability for Young Freshwater Pearl Mussels Using In Situ Exposure Methods
07:53

Bioindication Testing of Stream Environment Suitability for Young Freshwater Pearl Mussels Using In Situ Exposure Methods

Published on: September 5, 2018

Evacuate or shelter in place: A view from the water's edge

Mark P Jarrett1, Ziv Schwartz2, Mark Solazzo3

  • 1SVP & Chief Quality Officer, Associate Chief Medical Officer, Northwell Health, New Hyde Park, New York; Professor of Medicine, Zucker School of Medicine at Hofstra/Northwell, New Hyde Park, New York.

Journal of Emergency Management (Weston, Mass.)
|May 24, 2018
PubMed

More Related Videos

Developing a Virtual Reality Video Game to Simulate Rip Currents08:37

Developing a Virtual Reality Video Game to Simulate Rip Currents

Published on: July 16, 2020

A Field Primer for Monitoring Benthic Ecosystems Using Structure-From-Motion Photogrammetry06:36

A Field Primer for Monitoring Benthic Ecosystems Using Structure-From-Motion Photogrammetry

Published on: April 15, 2021

Related Concept Videos

States of Water01:23

States of Water

Water exists in any one of the three classical states: solid (ice), liquid (water), and gas (steam or water vapor). The state of water depends on i) the intermolecular forces that draw molecules together and ii) the kinetic energy that leads to movements that pull them apart.
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
Rab Cascades01:25

Rab Cascades

Rab GTPases act in a regulated cascade during membrane fusion, helping the lipid bilayers mix. The Rab family of proteins are active when bound to GTP, and inactive when bound to GDP. Hence, they act as guanine nucleotide-dependent molecular switches. Rab-GTP recognizes and binds to long or short-range tethering proteins to capture the target vesicle. These tethers coordinate with SNAREs on the vesicle and the target membrane to assemble the trans SNARE complex that locks the mixing bilayers.
Zones of Protection01:16

Zones of Protection

In power systems, the entire setup is divided into protective zones to isolate faults and protect the rest of the network. These zones include generators, transformers, buses, transmission lines, distribution lines, and motors. Each zone can be visualized as a separate room in a house, with each room protected by its own circuit breaker.
Protective zones are defined by closed dashed lines, containing one or more components. A key characteristic of these zones is the strategic placement of...
Design Example: Maintaining Level of an Embankment01:19

Design Example: Maintaining Level of an Embankment

Constructing a roadway embankment over uneven terrain requires precise leveling to ensure stability and proper drainage. Surveyors use a leveling instrument and staff to calculate ground elevations and determine the required fill material at each point along the embankment alignment.The process begins by positioning a leveling instrument near a benchmark with a known elevation. A backsight reading establishes the instrument height, which serves as a reference for subsequent measurements. A...
Buoyancy and Stability for Submerged and Floating Bodies01:11

Buoyancy and Stability for Submerged and Floating Bodies

In fluid mechanics, buoyancy and stability are key concepts for understanding the behavior of submerged and floating bodies. When a stationary body is fully or partially submerged in a fluid, the fluid exerts a force on the body known as the buoyant force. This force acts vertically upward through a point called the center of buoyancy, which is the center of the displaced fluid volume. According to Archimedes' principle, the magnitude of the buoyant force is equal to the weight of the fluid...
Design Example: Analyzing Capacity Contours for Flood Risk Assessment01:17

Design Example: Analyzing Capacity Contours for Flood Risk Assessment

Flood risk assessment involves careful planning and analysis to ensure the safety of communities near water retention structures. Capacity contours are a vital tool in this process, as they illustrate the potential spread of water at specific levels in a given area. In the context of building a bund across a small valley, these contours play a critical role in evaluating the safety of nearby residential areas.In this example, the bund is intended to store stormwater in the valley. The engineers...