Single-nucleus Hi-C of mammalian oocytes and zygotes

Johanna Gassler1, Ilya M Flyamer2, Kikuë Tachibana1

  • 1Institute of Molecular Biotechnology of the Austrian Academy of Sciences (IMBA), Vienna BioCenter (VBC), Vienna, Austria.

Related Concept Videos

The Nucleus01:32

The Nucleus

The nucleus is a membrane-bound organelle that acts as a control center in a eukaryotic cell. It contains chromosomal DNA, which controls gene expression and precisely regulates the production of proteins within the cell. In contrast, the DNA inside the mitochondria and chloroplast only carries out functions that are specific to those organelles.
Arrangement of DNA within Nucleus
The regulation of gene expression inside the nucleus is dependent on many factors, including the DNA structure. The...
103.9K
The Nucleus01:25

The Nucleus

The nucleus is a membrane-bound organelle that acts as a control center in a eukaryotic cell. It contains chromosomal DNA, which controls gene expression and precisely regulates the production of proteins within the cell. In contrast, the DNA inside the mitochondria and chloroplast only carries out functions that are specific to those organelles.
Arrangement of DNA within Nucleus
The regulation of gene expression inside the nucleus is dependent on many factors, including the DNA structure. The...
7.6K
Zygotic Development And Stem Cell Formation01:10

Zygotic Development And Stem Cell Formation

The development of all multicellular organisms starts with the fusion of haploid cells called sperm and egg to form a diploid zygote. A zygote is a totipotent cell that can develop into a complete organism. The zygote undergoes cell division or cleavage to form an 8-cell mass. Until this stage, the cells are spherical, loosely attached, and remain totipotent. Totipotent cells are capable of developing both the embryonic and the extraembryonic tissues. However, as they continue to divide, they...
6.8K
Load along a Single Axis01:29

Load along a Single Axis

In structural engineering, the analysis of beams subjected to varying loads is a critical aspect of understanding the behavior and performance of these structural elements. A common scenario involves a beam subjected to a combination of different load distributions.
Consider a beam of length L subjected to a varying load, which is a combination of parabolic and trapezoidal load distribution along the x-axis. In this case, it is essential to determine the resultant loads, their locations, and...
648
Single Pipe Systems01:24

Single Pipe Systems

In pipe flow analysis, problems are typically categorized into three types — Type I, Type II, and Type III — based on the known parameters and the desired outcome. Each type of problem addresses specific engineering requirements using fluid properties, pipe characteristics, and operational conditions.
In a Type I problem, fluid properties (density and viscosity), pipe characteristics (including diameter, length, and surface roughness), and the flow rate or average velocity are...
462
Angular Momentum: Single Particle01:10

Angular Momentum: Single Particle

Angular momentum is directed perpendicular to the plane of the rotation, and its magnitude depends on the choice of the origin. The perpendicular vector joining the linear momentum vector of an object to the origin is called the “lever arm.” If the lever arm and linear momentum are collinear, then the magnitude of the angular momentum is zero. Therefore, in this case, the object rotates about the origin such that it lies on the rim of the circumference defined by the lever arm...
7.8K