Muscle Activation in Unilateral Barbell Exercises: Implications for Strength Training and Rehabilitation
Lasse Mausehund1, Audun E Skard1, Tron Krosshaug2
1Department of Physiotherapy, Oslo and Akershus University College of Applied Sciences, Oslo, Norway.
Abstract:
Mausehund, L, Skard, AE, and Krosshaug, T. Muscle activation in unilateral barbell exercises: Implications for strength training and rehabilitation. J Strength Cond Res 33(7S): S85-S94, 2019-The purpose of the present investigation was to assess lower-body muscle activity and hamstrings-to-quadriceps (HQ) activation ratios during performance of the split squat (SS), single-leg squat (SLS), and rear foot elevated split squat (RFESS), while using the same relative load and performing the exercises to muscular failure. Eleven healthy, moderately strength-trained subjects performed a 6-8 repetition maximum set of each exercise while electromyographic (EMG) activity of the vastus lateralis, biceps femoris, gluteus maximus, and gluteus medius was recorded. The results show that there were no significant differences in EMG peak activity of the gluteus maximus and vastus lateralis between any of the exercises. Gluteus medius activation was significantly (p ≤ 0.05) higher during the SLS (81.9% maximum voluntary isometric contraction [MVIC]), compared with the RFESS (54.9% MVIC) and SS (46.2% MVIC). The RFESS elicited higher (p ≤ 0.05) biceps femoris activity (76.1% MVIC) than the SS (62.3% MVIC), as well as higher (p ≤ 0.05) HQ activation ratios (0.83) than the SS (0.69) and SLS (0.63). During the SLS and the SS, HQ activation ratios increased significantly in the course of the repetition maximum set. In conclusion, although absolute loading differs between exercises, similar training stimuli of the gluteus maximus and quadriceps femoris can be expected for all exercises. The SLS is likely to induce the greatest improvements in gluteus medius strength, whereas the RFESS should be preferred if high hamstring coactivation is desired. To improve validity in EMG studies, strength training exercises should be performed close to failure while using the same relative loading.
Related Concept Videos
Exercise and Muscle Performance
Endurance exercises
Endurance exercises involve running, swimming, or cycling, which require repetitive movements with low force output. When a person engages in endurance exercise, a few noticeable changes occur in their skeletal muscles. For instance, the number of capillaries...
Acid Strength and Molecular Structure
In the absence of any leveling effect, the acid strength of binary compounds of hydrogen with nonmetals (A) increases as the H-A bond strength decreases down a group in the periodic table. For group 17, the order of increasing acidity is HF < HCl < HBr < HI. Likewise, for group 16, the order of increasing acid strength is H2O < H2S < H2Se < H2Te. Across a row in the periodic table, the acid strength of binary hydrogen compounds increases with increasing...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Relation Between Tensile Strength and Compressive Strength of Concrete
Classification of Skeletal Muscle Fibers
Slow-Twitch Muscle Fibers
Slow oxidative, muscle fibers appear red due to large numbers of capillaries and high levels of...
The Equilibrium Binding Constant and Binding Strength


