The Ayre's T-piece turns 80: A 21^st century review

The auditory ossicles of the middle ear transmit sounds from the air as vibrations to the fluid-filled cochlea. The auditory ossicles consist of two malleus (hammer) bones, two incus (anvil) bones, and two stapes (stirrups), one on each side. These bones develop during the fetal stage and are the ones to ossify first. They are fully mature at birth and do not grow afterward.
The aptly named stapes look very much like a stirrup. The three ossicles are unique to mammals, and each plays a role in...

An ohmmeter is a resistance-measuring device. It works by applying a voltage to a resistor of unknown resistance and measuring the current across the resistor. The resistance value is deduced using Ohm's law. Usually, the standard configuration of an ohmmeter comprises a voltmeter or an ammeter. However, such configurations are limited in accuracy because the meters alter the voltage applied to the resistor and the current that flows through it.
Thus, for accurate resistance measurements, a...

Auditory sensation, commonly called hearing, involves the transformation of sonic waves into neural impulses facilitated by the structures of the auditory organ. The prominent, flesh-like structure on the side of the head, called the auricle, directs sound waves towards the auditory canal. The auricle is often mislabeled as the pinna, a term more aligned with mobile structures like a feline's external ear. The auditory canal penetrates the cranium via the external auditory meatus of the...

A sound engineer at a music company recently encountered a problem. The output from their newly acquired studio's vintage mixing console was too low for the requirements of modern recording equipment. To rectify this situation, the engineer decided to design an audio pre-amplifier using an operational amplifier (op-amp) to boost the signal level.
The specifications for the pre-amplifier were clear. It needed to amplify the audio signal by a factor of 10, have an input impedance above 10...

The aorta is the largest artery in the human body. It originates from the left ventricle of the heart and extends down to the abdomen, where it splits into two smaller arteries. Structurally, it can be divided into four main parts: the ascending aorta, the aortic arch, the thoracic aorta, and the abdominal aorta.
The average diameter of the aorta is approximately 2-3 cm, but the size can vary depending on the section of the aorta and the individual's age, sex, and body size. The aorta is...

In pipe flow analysis, problems are typically categorized into three types — Type I, Type II, and Type III — based on the known parameters and the desired outcome. Each type of problem addresses specific engineering requirements using fluid properties, pipe characteristics, and operational conditions.
In a Type I problem, fluid properties (density and viscosity), pipe characteristics (including diameter, length, and surface roughness), and the flow rate or average velocity are known. The...