Related Experiment Video
Updated: Feb 9, 2026

Three-Dimensional Printing Guide Template Assisted Percutaneous Vertebroplasty PVP
Published on: October 17, 2019
Minimally Invasive Translaminar Endoscopic Approach to Percutaneous Vertebroplasty Cement Leakage: Technical Note
Salim Şenturk1, Goktug Akyoldas1, Ülkün Ünlü Ünsal1
1Department of Neurosurgery, Koç University, Istanbul, Turkey.
Background:
Percutaneous vertebroplasty (PVP) and percutaneous kyphoplasty are 2 common procedures that could be applied simply in treatment of vertebral compression fractures. Despite simplicity and safe application of these procedures, there are some drawbacks as well. Cement leakage into the spinal canal is the most common complication of PVP and PKV procedures. The aim of this article is to present a minimally invasive alternative technique for removing cement leakage fragment after the PVP.
Methods:
A 44-year-old female patient began to complain of L4 radiculopathy after L4 PVP. The lumbar computed tomography demonstrated cement fragment closed to upper medial aspect of the left L4 pedicle. A minimally invasive translaminar endoscopic procedure was performed to remove the cement fragment.
Results:
Following the endoscopic procedure, the patient's complaints resolved completely and she was discharged on postoperative day 1. The minimally invasive intervention provided shorter operation time, minimal blood loss, and reduced complication rate due to its simplicity. In particular, there was no need to undergo general anesthesia.
Conclusions:
Endoscopic translaminar approach could be safely performed in patients with symptomatic cement leakage after PVP or a percutaneous kyphoplasty procedure.
Related Concept Videos
Hydration of Cement
Soundness of Cement
Portland Cement
Fineness of Cement
Direct...
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Types of Cement I
Type I (Ordinary Portland Cement) is widely used for general construction where special properties are not required. It has moderate sulfate resistance and heat of hydration.
Type II (Modified Cement) offers moderate resistance to sulfate attack and a lower rate of heat development compared to Type I. It is suitable for structures in...

