Related Experiment Video

Updated: Feb 9, 2026

Solution-Processed "Silver-Bismuth-Iodine" Ternary Thin Films for Lead-Free Photovoltaic Absorbers
10:19

Solution-Processed "Silver-Bismuth-Iodine" Ternary Thin Films for Lead-Free Photovoltaic Absorbers

Published on: September 27, 2018

10.2K

Low-density graphitic films prepared from iodine-doped enzymatically synthesized amylose films as carbonization

Bairu Yan1, Satoshi Matsushita1, Shiho Suzuki2

  • 1Department of Polymer Chemistry, Kyoto University, Katsura, Kyoto 615-8510, Japan.

Carbohydrate Polymers
|June 13, 2018
PubMed

Keywords:
Enzymatically synthesized amyloseIodine-doped amyloseLow-density graphitic filmsMorphology-retaining carbonizationSupercapacitor

More Related Videos

Synthesis and Functionalization of Nitrogen-doped Carbon Nanotube Cups with Gold Nanoparticles as Cork Stoppers11:58

Synthesis and Functionalization of Nitrogen-doped Carbon Nanotube Cups with Gold Nanoparticles as Cork Stoppers

Published on: May 13, 2013

23.5K
On the Preparation and Testing of Fuel Cell Catalysts Using the Thin Film Rotating Disk Electrode Method12:12

On the Preparation and Testing of Fuel Cell Catalysts Using the Thin Film Rotating Disk Electrode Method

Published on: March 16, 2018

22.9K

Related Concept Videos

The Carbon Cycle01:14

The Carbon Cycle

Carbon is the basis of all organic matter on Earth, and is recycled through the ecosystem in two primary processes: one in which carbon is exchanged among living organisms, and one in which carbon is cycled over long periods of time through fossilized organic remains, weathering of rocks, and volcanic activity. Human activities, including increased agricultural practices and the burning of fossil fuels, has greatly affected the balance of the natural carbon cycle.
43.9K
Carbon Skeletons01:12

Carbon Skeletons

Life on Earth is carbon-based, as all macromolecules that make up living organisms contain carbon atoms. All organic compounds have a carbon backbone. Each carbon atom is tetravalent and can bond with four other atoms, making it an extraordinarily flexible component of biological molecules. Because carbon’s valence electrons are stable, it rarely becomes an ion. As the carbon chain increases in length, structural modifications such as ring structures, double bonds, and branching side...
115.4K
Electrophilic Aromatic Substitution: Fluorination and Iodination of Benzene01:13

Electrophilic Aromatic Substitution: Fluorination and Iodination of Benzene

Bromination and chlorination of aromatic rings by electrophilic aromatic substitution reactions are easily achieved, but fluorination and iodination are difficult to achieve. Fluorine is so reactive that its reaction with benzene is difficult to control, resulting in poor yields of monofluoroaromatic products. To address this, Selectfluor reagent is used as a fluorine source in which a fluorine atom is bonded to a positively charged nitrogen.
7.5K
Density00:56

Density

Density is an important characteristic of substances, crucial in determining whether an object sinks or floats in a fluid. Its SI unit is kg/m3, and its cgs unit is g/cm3. The density of an object helps in identifying its composition, and also reveals information about the phase of the matter and its substructure. The densities of liquids and solids are roughly comparable, consistent with the fact that their atoms are in close contact. However, gases have much lower densities than liquids and...
19.9K
Carbonation Shrinkage01:24

Carbonation Shrinkage

Atmospheric CO2 penetrates the concrete's pores and, in the presence of moisture, forms carbonic acid, which then reacts with calcium hydroxide in the hydrated cement, forming calcium carbonate. This process reduces the concrete's volume and is termed carbonation shrinkage.
The concrete's permeability is slightly reduced as calcium carbonate produced during the reaction fills its pores. Furthermore, its strength is slightly enhanced as the water released during the reaction...
498
Current Density01:21

Current Density

The total amount of current flowing through one unit value of a cross-sectional area is referred to as current density. If the current flow is uniform, the amount of current flowing through a conductor is the same at all points along the conductor, even if the conductor area varies. The current density consists of the local magnitude and direction of the charge flow, which varies from point to point. Current density is measured in amperes per meter square, and direction is defined as the net...
5.2K