Prediction of tissue concentrations of monoclonal antibodies in mice from plasma concentrations

Iftekhar Mahmood1, Million A Tegenge2

  • 1Office of Tissue & Advanced Therapies (OTAT), Center for Biologics Evaluation and Research, Food & Drug Administration, 10903 New Hampshire Avenue, Silver Spring, MD, 20993-0002, USA.

The objectives of this study were to develop and evaluate allometric methods for predicting tissue-to-plasma partition coefficients (Kp) in mice from experimentally determined in-vivo volume of distribution at steady state (Vss) for monoclonal antibodies (mAbs). The Vss was allometrically predicted (using a fixed exponent 1.0 or 0.9) in a given tissue of the mice. The Kp was predicted using Vss and tissue specific physiological parameters. In total, Kp values were predicted for 20 mAbs, 121 tissues, and 665 tissue concentrations. The predicted Kp values and tissue concentrations were compared with the experimental results as well as an empirically predicted antibody biodistribution coefficient (ABC). Comparison of the predicted Kp values by the two proposed methods with experimentally determined Kp values indicated that 64-75% of the predicted Kp values were within two-fold prediction error. For 665 tissue concentrations, 63%, 74%, and 48% tissue concentration ratio were within 0.5-2 fold prediction error by exponent 1.0, exponent 0.9, and ABC, respectively. The proposed allometric methods are better than ABC method for the prediction of tissue Kp values and tissue concentrations. The proposed methods can reasonably predict tissue concentrations of mAbs using plasma concentration gathered at early stage of biologics development.

Related Concept Videos

Concentration Cells02:41

Concentration Cells

A concentration cell is a type of a  voltaic cell constructed by connecting two almost identical half-cells, both based on the same half-reaction and using the same electrode, differing only in the concentration of one redox species. A concentration cell's potential, therefore, is determined only by the concentration difference of the particular redox species.
Consider the following voltaic cell:
25.9K
Solution Concentration and Dilution02:59

Solution Concentration and Dilution

The relative amount of a given solution component is known as its concentration. Often, though not always, a solution contains one component with a concentration that is significantly greater than that of all other components. This component is called the solvent and may be viewed as the medium in which the other components are dispersed or dissolved. Solutions in which water is the solvent are, of course, very common on our planet. A solution in which water is the solvent is called an aqueous...
134.8K
Stress Concentrations01:13

Stress Concentrations

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress...
650
Stress Concentrations01:24

Stress Concentrations

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller...
715
Concentration and Rate Law03:03

Concentration and Rate Law

The rate of a reaction is affected by the concentrations of reactants. Rate laws (differential rate laws) or rate equations are mathematical expressions describing the relationship between the rate of a chemical reaction and the concentration of its reactants.
For example, in a generic reaction aA + bB ⟶ products, where a and b are stoichiometric coefficients, the rate law can be written as:
39.6K
Calculating Equilibrium Concentrations02:05

Calculating Equilibrium Concentrations

Being able to calculate equilibrium concentrations is essential to many areas of science and technology—for example, in the formulation and dosing of pharmaceutical products. After a drug is ingested or injected, it is typically involved in several chemical equilibria that affect its ultimate concentration in the body system of interest. Knowledge of the quantitative aspects of these equilibria is required to compute a dosage amount that will solicit the desired therapeutic effect.
A more...
53.7K