Prebiopsy biparametric MRI: differences of PI-RADS version 2 in patients with different PSA levels

M H Choi1, Y J Lee1, S E Jung1

  • 1Department of Radiology, Seoul St. Mary's Hospital, College of Medicine, The Catholic University of Korea, Seoul, Republic of Korea; Cancer Research Institute, College of Medicine, The Catholic University of Korea, Seoul, Republic of Korea.

Clinical Radiology
|June 14, 2018
PubMed
Abstract

Related Concept Videos

PI Controller: Design01:24

PI Controller: Design

Proportional Integral (PI) controllers are a fundamental component in modern control systems, widely used to enhance performance and mitigate steady-state errors. They are particularly effective in applications such as automatic brightness adjustment on smartphones, where they excel at mitigating steady-state errors for step-function inputs. Unlike PD controllers, which require time-varying errors to function optimally, PI controllers leverage their integral component to address residual...
1.3K
The Buckingham Pi Theorem01:09

The Buckingham Pi Theorem

The Buckingham Pi theorem provides a structured method to simplify fluid dynamics problems by reducing complex systems of variables to dimensionless terms.
1.6K
Determination of Pi Terms01:15

Determination of Pi Terms

The Buckingham Pi theorem is a valuable method in dimensional analysis, reducing complex relationships between variables into dimensionless terms. Relevant variables in analyzing the lift force on an airplane wing include lift force, air density, wing area, aircraft velocity, and air viscosity. Expressing each variable in terms of fundamental dimensions — mass, length, and time — provides a consistent foundation for constructing these dimensionless terms.
The theorem indicates that the...
629
Electric Potential and Potential Difference01:16

Electric Potential and Potential Difference

Suppose a positive test charge moves away from a positive static charge, then the Coulomb force does positive work, and its electric potential energy decreases. The potential energy per unit charge is defined as the electric potential. The electric potential is independent of the test charge.
When a test charge moves from the initial to the final position, the electric potential difference between those positions is defined as the ratio of the change in the potential energy to the charge on the...
5.7K
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
8.4K
Identifying Statistically Significant Differences: The F-Test01:14

Identifying Statistically Significant Differences: The F-Test

The F-test is used to compare two sample variances to each other or compare the sample variance to the population variance. It is used to decide whether an indeterminate error can explain the difference in their values. The underlying assumptions that allow the use of the F-test include the data set or sets are normally distributed, and the data sets are independent of each other. The test statistic F is calculated by dividing one variance by another. In other words, the square of one standard...
3.9K