Cocaine-Induced Structural Plasticity in Input Regions to Distinct Cell Types in Nucleus Accumbens

Cindy Barrientos1, Daniel Knowland2, Mingche M J Wu1

  • 1Neurobiology Section, Biological Sciences Division, University of California San Diego, La Jolla, California.

Biological Psychiatry
|June 21, 2018
PubMed
Abstract

Related Concept Videos

The Nucleus01:32

The Nucleus

The nucleus is a membrane-bound organelle that acts as a control center in a eukaryotic cell. It contains chromosomal DNA, which controls gene expression and precisely regulates the production of proteins within the cell. In contrast, the DNA inside the mitochondria and chloroplast only carries out functions that are specific to those organelles.
Arrangement of DNA within Nucleus
The regulation of gene expression inside the nucleus is dependent on many factors, including the DNA structure. The...
103.7K
The Nucleus01:25

The Nucleus

The nucleus is a membrane-bound organelle that acts as a control center in a eukaryotic cell. It contains chromosomal DNA, which controls gene expression and precisely regulates the production of proteins within the cell. In contrast, the DNA inside the mitochondria and chloroplast only carries out functions that are specific to those organelles.
Arrangement of DNA within Nucleus
The regulation of gene expression inside the nucleus is dependent on many factors, including the DNA structure. The...
7.6K
The Eukaryotic Promoter Region02:40

The Eukaryotic Promoter Region

The eukaryotic promoter region is a segment of DNA located upstream of a gene. It contains an RNA polymerase binding site, a transcription start site, and several cis-regulatory sequences.  The proximal promoter region is located in the vicinity of the gene and has cis-regulatory sequences and the core promoter. The core promoter is the binding site for RNA polymerase and is usually located between -35 and +35 nucleotides from the transcription start site. The distal promoter regions are...
18.9K
Types of Non-structural Cracks in Concrete01:28

Types of Non-structural Cracks in Concrete

Non-structural cracks are primarily of three types: plastic, early-age thermal, and drying shrinkage cracks. Plastic cracks are further classified into plastic shrinkage cracks and plastic settlement cracks.
Plastic shrinkage cracks typically form within hours after the concrete is poured. The concrete's surface dries faster than the bottom, creating tensile stress that the still-plastic concrete cannot withstand, leading to diagonal or randomly patterned cracks on the concrete surface.
511
Plasticity00:58

Plasticity

Plasticity is the property where an object loses its elasticity and undergoes irreversible deformation, even after the deformation forces are eliminated. If a material deforms irreversibly without increasing stress or load, then this is called ideal plasticity. For example, when a force is applied to an aluminum rod, it changes its shape, but it does not return to its original shape once the force is removed. Plastic deformation or ductility is thus a permanent deformation or change in the...
3.1K
Plasticizers01:31

Plasticizers

Water-reducers, or plasticizers, are chemical admixtures used in concrete to improve strength and workability. These additives reduce the water-cement ratio without compromising workability, lower the cement content while maintaining the same workability, or increase workability to assist concrete placement in inaccessible areas.
Plasticizers function by using surface-active agents to create repulsive electrostatic forces between cement particles. This dispersion enhances the concrete's...
374