[Rotavirus prevalence and genotype distribution in children with acute gastroenteritis in Adana province]

Özlem Özgür Gündeşlioğlu1, Emine Kocabaş1, Zeliha Haytoğlu2

  • 1Cukurova University Faculty of Medicine, Department of Pediatrics, Division of Pediatric Infectious Disease, Adana, Turkey.

Mikrobiyoloji Bulteni
|June 24, 2018
PubMed

Insights

This study tracked rotavirus genotypes in young children with gastroenteritis before vaccine introduction. G1P8 and G9P8 were dominant strains, with significant shifts in prevalence over four years.

Area of Science:

  • Virology
  • Pediatrics
  • Epidemiology

Background:

  • Rotavirus is a leading cause of acute gastroenteritis in children globally, particularly in developing nations.
  • Understanding circulating rotavirus genotypes is crucial for vaccine effectiveness and surveillance.

Purpose of the Study:

  • To determine rotavirus G and P genotypes in children under five with acute gastroenteritis in Adana, Turkey.
  • To analyze genotype distribution and changes before national rotavirus vaccine introduction.

Main Methods:

  • Fecal specimens from 201 children (December 2012-November 2016) were tested for rotavirus antigen using rapid immunochromatographic tests.
  • G and P genotyping was performed on antigen-positive samples using multiplex reverse-transcriptase polymerase chain reaction (RT-PCR).

Main Results:

  • The most common genotypes were G1P8 (29.9%) and G9P8 (21%).
  • Significant temporal shifts observed: G9P8 prevalence decreased (40% to 8.1%), while G1P8 increased (21.3% to 48.6%).
  • No correlation found between rotavirus genotype and disease onset age, sex, or dehydration risk.

Conclusions:

  • G1P8 and G9P8 were the predominant rotavirus strains before vaccine introduction in the region.
  • Continuous rotavirus surveillance is essential for monitoring vaccine effectiveness and detecting emerging strains.

Related Concept Videos

Prevalence and Incidence01:08

Prevalence and Incidence

In statistical epidemiology and health sciences, two essential metrics—prevalence and incidence—are fundamental for understanding disease dynamics within a population. These measures enable public health officials, epidemiologists, and researchers to assess the burden of diseases, allocate resources effectively, and design impactful public health policies and interventions.
Prevalence indicates the proportion of individuals in a population who have a specific disease or health...
1.9K
Drug Distribution: Volume of Distribution01:25

Drug Distribution: Volume of Distribution

The volume of distribution refers to the theoretical volume necessary to contain the entire amount of an administered drug at the same concentration observed in the blood plasma. The body's intracellular fluid compartment, which makes up two-thirds of the total body water, is contrasted with the extracellular fluid compartment—comprising plasma and interstitial fluid—that accounts for one-third. The volume of distribution can vary depending on the characteristics of the drug.
7.5K
F Distribution01:19

F Distribution

The F distribution was named after Sir Ronald Fisher, an English statistician. The F statistic is a ratio (a fraction) with two sets of degrees of freedom; one for the numerator and one for the denominator. The F distribution is derived from the Student's t distribution. The values of the F distribution are squares of the corresponding values of the t distribution. One-Way ANOVA expands the t test for comparing more than two groups. The scope of that derivation is beyond the level of this...
10.7K
Drug Dosing: Infants and Children01:29

Drug Dosing: Infants and Children

Pediatric patient dosages diverge from adults due to disparities in body surface area, total body water, and extracellular fluid per kilogram of body weight. The dosing regimen considers the variations in pharmacokinetics and pharmacology across distinct age groups, encompassing preterm newborns, infants, young children, older children, and adolescents. Calculation of pediatric patient doses is predicated on determining body surface area, which exhibits a superior correlation with the child's...
312
Distributed Loads01:19

Distributed Loads

Distributed loads are a common type of load that engineers and scientists encounter in various practical situations. Distributed loads often refer to a type of load spread over a surface or a structure and can be modeled as continuous force per unit area.
For example, consider a bookshelf filled with books stacked vertically adjacent to each other. The weight of the books is evenly distributed over the length of the shelf. As a result, the pressure at different locations on the surface of the...
978