Related Experiment Video
Updated: Feb 8, 2026

Effects of Exposure of Formaldehyde to a Rat Model of Atopic Dermatitis Induced by Neonatal Capsaicin Treatment
Published on: September 27, 2017
Eosinophils Determine Dermal Thickening and Water Loss in an MC903 Model of Atopic Dermatitis
Karmella Naidoo1, Ferdinand Jagot1, Lieke van den Elsen1
1Malaghan Institute of Medical Research, Wellington, New Zealand.
Abstract:
Atopic dermatitis (AD) is a highly debilitating disease with significant health impacts worldwide. It has been a difficult disease to treat because of the wide spectrum of clinical manifestations. Therefore, the current clinical management strategies are nonspecific. Previous studies have documented that AD disease progression is precipitated by a combination of skin barrier dysfunction, itch, and immune dysregulation. However, the precise roles played by effector cells and cytokines have not been fully elucidated. To address this, we established a prolonged model of AD, using MC903. The phenotype of this MC903 model closely resembles the one observed in AD patients, including inflammatory parameters, barrier dysfunction, itch, and histopathological characteristics, thereby providing a platform to evaluate targets for the treatment of AD. This model exposed cells and cytokines that are critically associated with disease severity, including eosinophils, TSLP, and IL-4/IL-13. Indeed, eosinophil depletion significantly ameliorated AD pathology, most notably barrier dysfunction, to a similar extent as blocking of the IL-4/IL-13 axis by genetic deletion of STAT6. Thus, this study has identified eosinophils to be critical for the development and maintenance of AD, thereby proposing these effector cells as therapeutic targets for the treatment of AD.
Related Concept Videos
Adaptations that Reduce Water Loss
Line Loss
Line loss impacts power delivery efficiency in a balanced three-phase circuit. The symmetry in such a circuit simplifies the...
Reducing Line Loss
With a step-up transformer at the source, the voltage is increased, thereby reducing the current in the transmission lines since power loss in...
States of Water
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
Energy Losses in Transformers
There are four main reasons for energy losses in transformers.
The first cause can be the high resistance of the...
Major Losses in Pipes
Fluid flow can be classified as laminar or turbulent, primarily based on the Reynolds number. This dimensionless number reflects the relative influence of inertial to viscous...

