Related Experiment Video
Updated: Feb 8, 2026

Tuning the Acidity of Pt/ CNTs Catalysts for Hydrodeoxygenation of Diphenyl Ether
Published on: August 17, 2019
[Transfer and Fate of Polybrominated Diphenyl Ethers in an Electrical Equipment Dismantling Area Using a Multimedia
Nan-Dong Xue1, Xuan-Yu Chen2, Bing Yang1
1State Key Laboratory of Environmental Criteria and Risk Assessment, Chinese Research Academy of Environmental Sciences, Beijing 100012, China.
Abstract:
The multimedia fugacity model (Ⅲ) was used to simulate the distribution, transfer and fate of typical polybrominated diphenyl ethers (PBDEs) in air, water, soil and sediment in an electrical equipment dismantling area in eastern China. The modeling data were compared with monitored values in air, soil and sediment for validation purpose. Moreover, the transfer fluxes between different compartments were analyzed in order to infer the main transfer process. Parameters of the model were tested and the key parameters were identified using sensitivity analysis method for BDE47 and BDE209.The results of sensitivity analysis indicated that vapor pressure, the lgKow value and half-life had significant influence on concentrations of PBDEs in different media. The results showed that when the system reached equilibrium, most of the PBDEs would be accumulated in soil and sediment. The air advection outflow and soil degradation were the major routes for PBDEs to disappear in the area. The results will provide the basis for the risk management of PBDEs contamination.
More Related Videos
Related Concept Videos
Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis
Ethers can be prepared from organic compounds by various methods. Some of them are discussed below,
Preparation of Ethers by Alcohol Dehydration
In this method, in the presence of protic acids, alcohol dehydrates to produce alkenes and ethers under different conditions. For example, in the presence of sulphuric acid, dehydration of ethanol at 413 K yields ethoxyethane, whereas it yields ethene at 443 K.
Crown Ethers
Structure and Nomenclature of Ethers
Ethers are organic compounds with an ether functional group which is characterized by an oxygen atom connected to two — identical or different — alkyl, aryl, or vinyl groups. The C–O–C linkage in dimethyl ether — the simplest ether — has an approximately tetrahedral bond angle of 110.3 degrees. The oxygen atom is sp3- hybridized, with the C–O distance being about 140 pm.
Classification of Ethers
Based on their attached substituent...
Fates of Pyruvate
In aerobic organisms, pyruvate is metabolized via the citric acid cycle to produce reduced coenzymes NADH and FADH2. These coenzymes are then oxidized in the electron transport chain to produce ATP and, in the process, regenerate the NAD+ and FAD. As seen in some cell types and organisms, fermentation...
Leveling Equipment
Physical Properties of Ethers
An ether molecule has a net dipole moment due to the polarity of C–O bonds. Subsequently, boiling points of ethers are lower than those of alcohols of comparable molecular weight and slightly higher than those of hydrocarbons of comparable molecular weight (Table 1).
Ethers can act as hydrogen bond acceptors, making them more water-soluble than hydrocarbons, but since ethers cannot act as hydrogen bond donors, they are much less soluble in water than alcohols. Ethers are considered...

