Cold acclimation conditions constrain plastic responses for resistance to cold and starvation in Drosophila immigrans

Ankita Pathak1, Ashok Munjal1, Ravi Parkash2

  • 1Department of Biochemistry and Genetics, Barkatullah University, Bhopal, 462026, India.

Biology Open
|July 4, 2018
PubMed

Related Concept Videos

Responses to Heat and Cold Stress02:45

Responses to Heat and Cold Stress

Every organism has an optimum temperature range within which healthy growth and physiological functioning can occur. At the ends of this range, there will be a minimum and maximum temperature that interrupt biological processes.
14.9K
Masonry in Cold and Hot Weather Conditions01:21

Masonry in Cold and Hot Weather Conditions

In cold weather, masonry construction requires specific precautions to ensure mortar does not freeze before curing, as this can significantly weaken its strength and watertightness. Mortar temperature should be maintained between 60°F and 80°F to support proper hydration and curing. Below 40°F, mortar water must be heated, but should not exceed 120°F as high temperatures can reduce mortar's compressive and bond strength.
Other key practices include keeping masonry units...
349
Cold Weather Concreting01:27

Cold Weather Concreting

When freshly poured concrete is exposed to freezing temperatures before it has set, the water within the concrete can freeze. This expansion disrupts the setting process, delays chemical reactions necessary for hardening, and increases the volume of pores within the hardened concrete, which weakens its overall structure. If the concrete manages to reach an appreciable strength before it freezes, the damage can be somewhat mitigated.
To counteract the negative impacts of cold weather, ensuring...
387
Plasticity00:58

Plasticity

Plasticity is the property where an object loses its elasticity and undergoes irreversible deformation, even after the deformation forces are eliminated. If a material deforms irreversibly without increasing stress or load, then this is called ideal plasticity. For example, when a force is applied to an aluminum rod, it changes its shape, but it does not return to its original shape once the force is removed. Plastic deformation or ductility is thus a permanent deformation or change in the...
3.1K
Plasticizers01:31

Plasticizers

Water-reducers, or plasticizers, are chemical admixtures used in concrete to improve strength and workability. These additives reduce the water-cement ratio without compromising workability, lower the cement content while maintaining the same workability, or increase workability to assist concrete placement in inaccessible areas.
Plasticizers function by using surface-active agents to create repulsive electrostatic forces between cement particles. This dispersion enhances the concrete's...
374
Metabolic States of the Body: Fasting and Starvation01:24

Metabolic States of the Body: Fasting and Starvation

During the initial hours of fasting, the body uses up its glycogen stores as an energy source. Once these glycogen reserves are depleted, the body begins breaking down stored triglycerides and structural proteins. During this stage, glycerol becomes a key substrate for gluconeogenesis, while free fatty acids undergo beta-oxidation to provide energy for tissues, such as skeletal muscle. In the fasting state, the body spares protein breakdown as much as possible to conserve muscle and structural...
2.9K