Raman Spectroscopy of Multi-Layer Graphene epitaxially Grown on 4H-SiC by Joule Heat Decomposition
Zhiwei Zhang1, Weiwei Cai1,2,3, Rongdun Hong4,5
1Department of Physics, Xiamen University, Xiamen, 361005, People's Republic of China.
Abstract:
We developed a Joule heating decomposition (JHD) method, which applied direct current on the SiC for the epitaxial growth of multi-layer graphene (MLG) films on Si-terminated (0001) face of the high doping 4H-SiC substrate. By this JHD method, the growth time for preparing MLG was only several minutes. Raman spectroscopy was employed to study the influence of the temperature caused by the Joule heating on the quality and the uniformity of the sample. Then, other properties, such as the strain, the layer's number, and the electric characteristics, of the MLG were studied in details. It was found that the quality of the MLG was substantially dependent on the growth temperature (operation current) and the growth time, while the layer's number was only dependent on the growth temperature but not the growth time. Finally, less-defect and homogeneous MLG (~ 45 layers) with an area of ~ 12 × 5 mm2 could be obtained at a heating temperature of ~ 1470 °C with duration time of 5 min. By using the linear transmission line method, the specific contact resistance of Au and MLG was 5.03 × 10-5 Ω cm2, and the sheet resistance was 52.36 Ω/sq, respectively.
More Related Videos
06:57Theoretical Calculation and Experimental Verification for Dislocation Reduction in Germanium Epitaxial Layers with Semicylindrical Voids on Silicon
Published on: July 17, 2020
09:45Epitaxial Growth of Perovskite Strontium Titanate on Germanium via Atomic Layer Deposition
Published on: July 26, 2016
Related Concept Videos
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and...
Synthesis and Decomposition Reactions
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
Quantifying Heat
Joule-Thomson Effect
This experiment forces high-pressure gas through a throttle valve or a porous plug to a lower-pressure region. The gas expands as it passes through to...
Specific Heat
For example, increasing the temperature of one gram of water by 1°C requires one calorie of heat energy and can be written as 1 cal/g-°C, or...
