Related Experiment Video
Updated: Feb 7, 2026
Author Spotlight: Advancing CBCT and Digital Dental Image Integration with AI-Assisted Digitization
Published on: February 23, 2024
Is the pneumatisation of the maxillary sinus following tooth loss a reality? A retrospective analysis using cone beam
Martina Schriber1, Michael M Bornstein2, Valerie G A Suter3
1Department of Oral Surgery and Stomatology, School of Dental Medicine, University of Bern, Freiburgstrasse 7, 3010, Bern, Switzerland.
Objectives:
To compare the dimensions of maxillary sinuses in dentate and edentulous patients using cone beam computed tomography (CBCT) scans and a customised software program.
Materials And Methods:
This study comprised CBCTs of 50 dentate and 50 edentulous posterior maxillae. The observers drew two planar curves in all included sinuses in the frontal, sagittal and axial planes of the respective CBCT scans. The volume (mm3), surface (mm2) and maximum diameter (mm) of the sinuses were calculated using a custom-made software program. The variables analysed were the influence of the state of dentition on sinus dimensions (primary outcome) and the influence of age, gender and side on sinus dimensions; the time needed for analysis; and the intra- and inter-observer agreement (secondary outcomes).
Results:
There was no difference in sinus dimensions between dentate and edentulous posterior maxillae. Males had significantly (p < 0.05) greater volume, surface and diameter than females. Strong intra- and inter-observer agreement (Pearson correlation) was found for the calculated sinus dimensions. The time needed per analysis was less than 4 min for both observers.
Conclusions:
Being edentulous did not have an impact on the sinus dimensions, suggesting that there is no ongoing pneumatisation in the sinus after tooth loss. Males had larger sinuses than females in a population older than 30 years.
Clinical Relevance:
Following tooth loss in the posterior maxilla, vertical bone height is primarily lost due to resorption of the alveolar crest, and not due to pneumatisation of the maxillary sinus. The customised software program was found to be user-friendly and efficient.
More Related Videos
09:49Dual-phase Cone-beam Computed Tomography to See, Reach, and Treat Hepatocellular Carcinoma during Drug-eluting Beads Transarterial Chemo-embolization
Published on: December 2, 2013
10:50A Finite Element Approach for Locating the Center of Resistance of Maxillary Teeth
Published on: April 8, 2020
Related Concept Videos
01:10Computed Tomography
The technique was invented in the 1970s and is based on the principle that as X-rays pass through the body, they are absorbed or reflected at different levels. In the technique, a patient lies on a motorized platform while a computerized axial tomography (CAT) scanner rotates...
01:27Imaging Studies III: Computed Tomography
01:12Statistical Software for Data Analysis and Clinical Trials
01:21Tooth Anatomy
The Crown, Neck, and Root
The visible part of the tooth is referred to as the crown. It's covered by enamel, the hardest substance in the human body. The crown is uniquely shaped for each type of tooth, allowing for different functions such as cutting, tearing, or...
01:10Line Loss
Line loss impacts power delivery efficiency in a balanced three-phase circuit. The symmetry in such a circuit simplifies the...
01:30Beams
Based on geometry, beams can be straight, tapered, or curved. Straight beams are the most common type and have a constant cross-section throughout their length. Tapered beams, on the other hand, have a varying cross-section along...