A metabolic energy expenditure model with a continuous first derivative and its application to predictive simulations

Anne D Koelewijn1, Eva Dorschky2, Antonie J van den Bogert1

  • 1a Department of Mechanical Engineering , Cleveland State University , 1960 E 24th St , Cleveland , OH , 44115 , USA.

Related Concept Videos

Conservation of Energy: Application01:12

Conservation of Energy: Application

When solving problems using the energy conservation law, the object (system) to be studied should first be identified. Often, in applications of energy conservation, we study more than one body at the same time. Second, identify all forces acting on the object and determine whether each force doing work is conservative. If a non-conservative force (e.g., friction) is doing work, then mechanical energy is not conserved. The system must then be analyzed with non-conservative work. Third, for...
8.3K
Application of the Energy Equation01:04

Application of the Energy Equation

The application of the energy equation to centrifugal pumps is a fundamental principle in fluid dynamics and engineering. In this scenario, the energy equation is used to calculate the flow rate of a centrifugal pump responsible for transferring water between two reservoirs at different elevations. The pump applies an energy input of 7500 joules per second, and the vertical difference between the lower and upper reservoirs is 10 meters. Additionally, the head loss due to friction and other...
1.2K
What is Metabolism?00:52

What is Metabolism?

Overview
132.0K
Free Energy01:21

Free Energy

Free energy—abbreviated as G for the scientist Gibbs who discovered it—is a measurement of useful energy that can be extracted from a reaction to do work. It is the energy in a chemical reaction that is available after entropy is accounted for. Reactions that take in energy are considered endergonic and reactions that release energy are exergonic. Plants carry out endergonic reactions by taking in sunlight and carbon dioxide to produce glucose and oxygen. Animals, in turn, break...
52.1K
Activation Energy01:26

Activation Energy

Activation energy is the minimum amount of energy necessary for a chemical reaction to move forward. The higher the activation energy, the slower the rate of the reaction. However, adding heat to the reaction will increase the rate, since it causes molecules to move faster and increase the likelihood that molecules will collide. The collision and breaking of bonds represents the uphill phase of a reaction and generates the transition state. The transition state is an unstable high-energy state...
86.8K
Free Energy and Equilibrium02:56

Free Energy and Equilibrium

The free energy change for a process may be viewed as a measure of its driving force. A negative value for ΔG represents a driving force for the process in the forward direction, while a positive value represents a driving force for the process in the reverse direction. When ΔGrxn is zero, the forward and reverse driving forces are equal, and the process occurs in both directions at the same rate (the system is at equilibrium).
Recall that Q is the numerical value of the mass action...
27.3K