Related Experiment Video

Updated: Feb 7, 2026

A Standardized Procedure for Monitoring Harmful Algal Blooms in Chile by Metabarcoding Analysis
09:47

A Standardized Procedure for Monitoring Harmful Algal Blooms in Chile by Metabarcoding Analysis

Published on: August 26, 2021

6.2K

Algal blooms detection in Colombian Caribbean Sea using MODIS imagery

Karold Viviana Coronado-Franco1, John Josephraj Selvaraj1, José Ernesto Mancera Pineda2

  • 1Universidad Nacional de Colombia, Sede Palmira, Facultad de Ingeniería y Administración, Departamento de Ingeniería, Grupo de Investigación en Recursos Hidrobiológicos, Cra 32 No. 12 - 00, Palmira, Código Postal 763533 - Colombia.

Marine Pollution Bulletin
|July 26, 2018
PubMed

Keywords:
Algal bloomsColombian Caribbean SeaFluorescence Line HeightMODISRemote sensing

More Related Videos

Early Detection of Cyanobacterial Blooms and Associated Cyanotoxins using Fast Detection Strategy07:13

Early Detection of Cyanobacterial Blooms and Associated Cyanotoxins using Fast Detection Strategy

Published on: February 25, 2021

4.5K
Investigating the Relationship between Sea Surface Chlorophyll and Major Features of the South China Sea with Satellite Information10:28

Investigating the Relationship between Sea Surface Chlorophyll and Major Features of the South China Sea with Satellite Information

Published on: June 13, 2020

6.4K

Related Concept Videos

Effect of Sea Water on Concrete01:22

Effect of Sea Water on Concrete

Concrete exposed to seawater can undergo degradation like the dissolution of ettringite and gypsum, increasing the material's porosity and decreasing its strength. In contrast, the crystallization of salts within the concrete's pores can cause expansion, particularly above the waterline where evaporation occurs. Nonetheless, this expansion only happens when seawater, enabled by the concrete's permeability, manages to infiltrate the structure.
Concrete in areas between tide marks,...
1.1K
The Phosphorus Cycle01:21

The Phosphorus Cycle

Unlike carbon, water, and nitrogen, phosphorus is not present in the atmosphere as a gas. Instead, most phosphorus in the ecosystem exists as compounds, such as phosphate ions (PO43-), found in soil, water, sediment and rocks. Phosphorus is often a limiting nutrient (i.e., in short supply). Consequently, phosphorus is added to most agricultural fertilizers, which can cause environmental problems related to runoff in aquatic ecosystems.
44.0K
Detection of Gross Error: The Q Test01:00

Detection of Gross Error: The Q Test

When one or more data points appear far from the rest of the data, there is a need to determine whether they are outliers and whether they should be eliminated from the data set to ensure an accurate representation of the measured value. In many cases, outliers arise from gross errors (or human errors) and do not accurately reflect the underlying phenomenon. In some cases, however, these apparent outliers reflect true phenomenological differences. In these cases, we can use statistical methods...
7.0K
Detection of Black Holes01:10

Detection of Black Holes

Although black holes were theoretically postulated in the 1920s, they remained outside the domain of observational astronomy until the 1970s.
Their closest cousins are neutron stars, which are composed almost entirely of neutrons packed against each other, making them extremely dense. A neutron star has the same mass as the Sun but its diameter is only a few kilometers. Therefore, the escape velocity from their surface is close to the speed of light.
Not until the 1960s, when the first neutron...
2.6K
Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
8.4K
Effects of EDTA on End-Point Detection Methods01:18

Effects of EDTA on End-Point Detection Methods

Different methods, such as visual observance of metal-ion indicators, spectroscopic techniques, and potentiometric methods, can determine the endpoint of an EDTA titration.
In the visual method, metal-ion indicators (metallochromic dyes), which have distinct colors in their free and complex forms, are added to the mixture to signal the titration's end point. They form stable complexes with metal ions, but these complexes are weaker than the corresponding metal–EDTA complexes. As a...
667