The effectiveness of scaling procedures for comparing ground reaction forces

Various scaling methods are used when attempting to remove the influence of anthropometric differences on ground reaction forces (GRF) when comparing groups. Though commonly used, ratio scaling often results in an over-correction. Allometric scaling has previously been suggested for kinetic variables but its effectiveness in partialing out the effect of anthropometrics is unknown due to a lack of consistent application. This study examined the effectiveness of allometric scaling vertical, braking and propulsive GRF and loading rate for 84 males and 47 females while running at 4.0 m/s. Raw, unfiltered data were ratio scaled by body mass (BM), height (HT), and BM multiplied by HT (BM∗HT). Gender specific exponents for allometric scaling were determined by performing a log-linear (for BM and HT individually) or log-multilinear regression (BMHT). Pearson productmoment correlations were used to assess the effectiveness of each scaling method. Ratio scaling by BM, HT, or BM∗HT resulted in an over-correction of the data for most variables and left a considerable portion of the variance still attributable to anthropometrics. Allometric scaling by BM successfully removed the effect of BM and HT for all variables except for braking GRF in males and vertical GRF in females. However, allometric scaling for BMHT successfully removed the effect of BM and HT for all reactionary forces in both genders. Based on these results, allometric scaling for BMHT was the most appropriate scaling method for partialing out the effect of BM and HT on kinetic variables to allow for effective comparisons between groups or individuals.