Vancomycin concentrations in the cervical spine after intravenous administration: results from an experimental pig

Mats Bue1,2, Pelle Hanberg1,2, Mikkel Tøttrup3,4

  • 1a Department of Orthopaedic Surgery , Horsens Regional Hospital , Horsens.

Acta Orthopaedica
|August 7, 2018
PubMed

Related Concept Videos

Imaging Studies V: Intravenous Urography and Retrograde Pyelography01:22

Imaging Studies V: Intravenous Urography and Retrograde Pyelography

IntroductionIntravenous Urography (IVU) and Retrograde Pyelography (RP) are important diagnostic imaging techniques used to evaluate the urinary system. These methods help identify structural abnormalities, obstructions, and functional issues in the kidneys, ureters, and bladder. Both procedures use iodine-based contrast media to enhance the visibility of urinary tract structures on X-ray images, though they differ in their methods and indications.1. Intravenous Urography (IVU)Intravenous...
1.6K
Concentration Cells02:41

Concentration Cells

A concentration cell is a type of a  voltaic cell constructed by connecting two almost identical half-cells, both based on the same half-reaction and using the same electrode, differing only in the concentration of one redox species. A concentration cell's potential, therefore, is determined only by the concentration difference of the particular redox species.
Consider the following voltaic cell:
25.9K
Concentration and Rate Law03:03

Concentration and Rate Law

The rate of a reaction is affected by the concentrations of reactants. Rate laws (differential rate laws) or rate equations are mathematical expressions describing the relationship between the rate of a chemical reaction and the concentration of its reactants.
For example, in a generic reaction aA + bB ⟶ products, where a and b are stoichiometric coefficients, the rate law can be written as:
39.4K
Solution Concentration and Dilution02:59

Solution Concentration and Dilution

The relative amount of a given solution component is known as its concentration. Often, though not always, a solution contains one component with a concentration that is significantly greater than that of all other components. This component is called the solvent and may be viewed as the medium in which the other components are dispersed or dissolved. Solutions in which water is the solvent are, of course, very common on our planet. A solution in which water is the solvent is called an aqueous...
134.7K
Stress Concentrations01:13

Stress Concentrations

The concept of stress concentration is crucial for understanding how materials respond under bending stresses, particularly when there are irregularities or discontinuities in the material's geometry. Normally, stress in a symmetric member subjected to pure bending is assumed to be uniformly distributed across the entire cross-section. However, this assumption does not hold when there are variations in the cross-sectional geometry or the presence of notches and holes.
The stress...
648
Stress Concentrations01:24

Stress Concentrations

Stress concentration is when stress intensifies near discontinuities such as holes or abrupt cross-sectional changes in a structural member. This localized stress can often surpass the average stress within the member. The stress distribution in flat bars, either with a circular hole or varying widths connected by fillets, can be determined experimentally using a photoelastic method. The results are based on ratios of geometric parameters like the ratio of the hole's radius to the smaller...
714