Safety of 5914 intravitreal ziv-aflibercept injections

Sumit Randhir Singh1, Michael W Stewart2, Goura Chattannavar1

  • 1Smt. Kanuri Santhamma Centre for Vitreo-Retinal Diseases, L V Prasad Eye Institute, Hyderabad, India.

Related Concept Videos

Survey Safety01:28

Survey Safety

Surveying near highways, rough terrain, or power lines involves significant risks. Working along highways is particularly dangerous and requires the use of warning signs and flagmen. It is safest to avoid working directly on roads and use offsets whenever possible. When highway work is unavoidable, it must follow all safety guidelines. Surveyors should wear bright clothing, such as orange reflective vests, to ensure visibility to motorists, coworkers, and hunters. In construction zones, wearing...
410
Household Wiring And Electrical Safety01:13

Household Wiring And Electrical Safety

Companies that supply power to most modern households use three conductors, typically called a three-wire line. While one is neutral, the other two are both at 120 V but with opposite polarity, giving a voltage of 240 V between them. With a three-wire line, high-power appliances that require 240 V, such as electric stoves and clothes dryers, are linked between the two hot lines. 120 V appliances can be connected between the neutral and either of the hot lines. The neutral side, which is always...
1.7K
Gas Chromatography: Sample Injection Systems01:08

Gas Chromatography: Sample Injection Systems

In gas chromatography, the sample is introduced as a vapor plug into the carrier gas stream for high efficiency and resolution. A microsyringe injects the sample solution into a heated sample port, vaporizing it and mixing it with the carrier gas. This process is important to ensure the sample is properly prepared for analysis. Thermally sensitive samples can be injected directly into the column and volatilized by slowly increasing the column temperature.
Two primary injection methods are used...
1.6K
Nonlinear Pharmacokinetics: Drug Elimination for IV Bolus Injection00:59

Nonlinear Pharmacokinetics: Drug Elimination for IV Bolus Injection

In pharmacokinetics, the elimination rate of a drug following a capacity-limited model is primarily controlled by two parameters: Vmax and KM. These parameters are crucial in how the drug behaves inside the body after administration.
Following the administration of a single intravenous (IV) bolus injection, we can determine the concentration of the drug in the plasma at any given time. This calculation is achieved using a specific equation that integrates the values of Vmax and KM.
We can also...
426
Drug Accumulation During Multiple Dosing: Repetitive IV Injections01:21

Drug Accumulation During Multiple Dosing: Repetitive IV Injections

Calculating drug dosage and accumulation in multiple-dose regimens is crucial for achieving therapeutic efficacy while avoiding toxicity. This involves determining the plasma drug concentrations over time to optimize dosing schedules. The principle of superposition is fundamental in this process, allowing for the prediction of drug concentration in plasma following multiple doses based on single-dose data.The principle of superposition asserts that the plasma concentration-time curves from...
289
Bystander Effect02:09

Bystander Effect

The discussion of bullying highlights the problem of witnesses not intervening to help a victim. This is a common occurrence, as the following well-publicized event demonstrates. In 1964, in Queens, New York, a 19-year-old woman named Kitty Genovese was attacked by a person with a knife near the back entrance to her apartment building and again in the hallway inside her apartment building. When the attack occurred, she screamed for help numerous times and eventually died from her stab wounds.
10.3K