Related Experiment Video
Updated: Feb 6, 2026

A System to Create Stable Nanoparticle Aerosols from Nanopowders
Published on: July 26, 2016
Aerosol source (biomass, traffic and coal emission) apportionment in Lithuania using stable carbon and radiocarbon
Andrius Garbaras1,2, Justina Šapolaitė1, Inga Garbarienė1
1a Mass Spectrometry Laboratory , State Research Institute Center for Physical Sciences and Technology , Vilnius , Lithuania.
Abstract:
In the present study, a combination of the stable carbon isotope ratio (13C/12C) with radiocarbon data (14C) allowed us to perform the aerosol source apportionment. Filter samples of PM1 were collected during the warm and cold periods in rural and urban sites in Lithuania. The 14C/12C ratio of total carbon (TC) was measured using the single stage accelerator mass spectrometer quantifying of fossil and non-fossil derived aerosol emissions. The δ13C value was measured using an elemental analyser interfaced with an isotope ratio mass spectrometer. We have found that the highest fraction of contemporary carbon (fc = 0.82) was measured during a warm period in a rural location. A higher fraction of fossil fuel-derived carbon was observed for air masses transported from highly industrialized Western European regions during both seasons. Isotope mass balance calculations revealed that the traffic emissions composed 15 and 25 % in rural and urban sites, respectively, and did not change during either season. Input from coal-derived aerosol particles was estimated to be 15 % at an urban site during the cold period. The combination of the stable carbon isotope ratio with the radiocarbon data allowed us to distinguish coal, liquid fossil fuel combustion, and non-fossil derived aerosol particle emissions.
Related Concept Videos
Introduction to Membrane Traffic
The transport of soluble and membrane proteins is mediated by transport vesicles that collect cargo from one cellular compartment and deliver it to another by fusing with the target organelle membrane. The Rab...
Emission Spectra
Mesh Analysis with Current Sources
Current Source in One Mesh: The analysis process is straightforward when a current source is found in only one mesh within the circuit. Mesh currents are assigned as usual, with the mesh containing the current source excluded from the analysis. Kirchhoff's voltage law...
Nodal Analysis with Voltage Sources
Consider a circuit that contains four resistors and two voltage sources, as shown in Figure 1. One of these voltage sources is connected between a...
The Carbon Cycle
Carbon Skeletons

