Q-switching and quasi-phase-matching using a domain structured LiNbO₃ crystal

Ionic crystals consist of two or more different kinds of ions that usually have different sizes. The packing of these ions into a crystal structure is more complex than the packing of metal atoms that are the same size.
Most monatomic ions behave as charged spheres, and their attraction for ions of opposite charge is the same in every direction. Consequently, stable structures for ionic compounds result (1) when ions of one charge are surrounded by as many ions as possible of the opposite...

Phase-lead controllers are commonly used in various control systems to enhance response speed and stability. Adjusting the brightness on a television screen offers a practical example of phase-lead control. When contrast is enhanced, a phase-lead controller is employed. Mathematically, phase-lead control is identified when the first parameter is smaller than the second.
The design of phase-lead control involves the strategic placement of poles and zeros to balance steady-state error and system...

Phase-lag controllers are widely used in control systems to improve stability and reduce steady-state errors. A dimmer switch controlling the brightness of a light bulb serves as a practical example of phase-lag control, gradually adjusting the bulb's brightness. Mathematically, phase-lag control or low-pass filtering is represented when the factor 'a' is less than 1.
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any...

Protein domains are small structurally independent units that are part of a single amino acid chain.  Although these domains are often structurally independent, they may rely on synergistic effects to perform their functions as part of a larger protein. Protein domains may be conserved within the same organism, as well as across different organisms.
A limited set of protein domains often duplicate and recombine during evolution. These domains can be organized in different combinations to...

The sign test for matched pairs offers a robust method for comparing two paired samples, often for the effects of an intervention in one of them. This method is very useful in situations where the underlying distribution of the data is unknown. The test compares two related samples—often pre- and post-treatment measurements on the same subjects—to determine if there are significant differences in their median values.
To conduct the sign test, we first calculate the differences in...

Switching behavior in Bipolar Junction Transistors (BJTs) is a fundamental aspect utilized in various electronic circuits, particularly for digital logic applications like switches and amplifiers. In a typical switching circuit, a BJT alternates between cut-off and saturation modes, corresponding to the "off" and "on" states, respectively, thus behaving like an ideal switch.
Cut-off Mode ("Off" State): In this state, both the emitter-base and collector-base junctions are...