Magneto-elastic switching of magnetostrictive nanomagnets with in-plane anisotropy: the effect of material defects

Md Ahsanul Abeed1, Jayasimha Atulasimha1,2, Supriyo Bandyopadhyay1

  • 1Department of Electrical and Computer Engineering, Virginia Commonwealth University, Richmond, VA 23284, United States of America.

Related Concept Videos

Yield Criteria for Ductile Materials under Plane Stress01:25

Yield Criteria for Ductile Materials under Plane Stress

In designing structural elements and machine parts using ductile materials, it is crucial to ensure that these components withstand applied stresses without yielding. Yielding is initially determined through a tensile test, which evaluates the material's response to uniaxial stress. However, tensile stress is insufficient when components face biaxial or plane stress conditions This condition requires advanced criteria to predict failure.
The Maximum Shearing Stress Criterion, also known as...
562
Switching of BJT01:22

Switching of BJT

Switching behavior in Bipolar Junction Transistors (BJTs) is a fundamental aspect utilized in various electronic circuits, particularly for digital logic applications like switches and amplifiers. In a typical switching circuit, a BJT alternates between cut-off and saturation modes, corresponding to the "off" and "on" states, respectively, thus behaving like an ideal switch.
Cut-off Mode ("Off" State): In this state, both the emitter-base and collector-base junctions are...
866
Elasticity01:12

Elasticity

Elasticity is the ability of an object to withstand the effects of distortion and to return to its original size and shape once the forces causing deformation are removed. When an elastic material deforms under the action of an external force, it experiences internal resistance to the deformation. However, if no external force is applied, it returns to its original state.
The elasticity of an object can be described by a stress-strain curve, which represents the relationship between stress...
4.9K
Work Done Over an Inclined Plane01:11

Work Done Over an Inclined Plane

The center-of-mass framework helps to easily describe the work done on rigid bodies. Since the internal forces in a rigid body do no work, they can be ignored, and the external forces can be considered in the work-energy theorem.
The work done by gravity to move a rigid body, or the work done by an opposing force to move a rigid body against gravity, can be calculated using the center-of-mass framework. It is the line integral of the force of gravity over the path, considered positive if...
4.0K
Lumber Defects01:23

Lumber Defects

Lumber defects, which can affect both the appearance and structural integrity of wood, include a variety of growth and manufacturing flaws. Growth defects such as knots and knotholes occur where branches were once attached to the tree trunk, with knotholes forming when these knots fall out. Other natural defects include decay and insect damage, which compromise the wood's strength and durability.
Shakes are minor fractures that run along or across the wood's annual rings, while wane is...
529
Elasticity in Concrete01:20

Elasticity in Concrete

Upon subjecting concrete to moderate or high uniaxial compressive or tensile stresses, the strain response is non-linear relative to the stress applied. As the stress is removed, the resulting stress-strain curve deviates from the original path traced during loading, creating a hysteresis loop, indicative of the concrete's non-linear and non-elastic properties. Typically, a material's modulus of elasticity, which is a measure of the material's stiffness, is inferred from the linear...
363