Clinical and radiological analysis of a personalized total knee arthroplasty system design

Francesco Benazzo1, Matteo Ghiara2, Stefano Marco Paolo Rossi1

  • 1Department of Clinical-Surgical Sciences, Diagnostics and Pediatrics, Operative Unit of Orthopaedics and Traumatology, Fondazione IRCCS Policlinico San Matteo, University of Pavia, Via Golgi, 19, 27100, Pavia, Italy.

Abstract

Related Concept Videos

Knee Joint01:23

Knee Joint

The knee joint is the most complicated joint in the body. It consists of three articulations– two tibiofemoral and one patellofemoral. As is characteristic of synovial joints, the knee joint has a thin articular capsule that partially surrounds this joint cavity. Additionally, several ligaments, muscles, and cartilaginous structures support the movement of the knee.
A total of seven ligaments support the knee joint. The patellar ligament, which is also attached to the quadriceps femoris...
3.3K
Radiological Investigation I: X-ray and CT01:30

Radiological Investigation I: X-ray and CT

Radiological investigations, including X-rays and computed tomography (CT) scans, are critical for diagnosing and evaluating various medical conditions. These imaging techniques provide valuable insights into the body's internal structures, aiding in the detection of abnormalities, assessment of disease progression, and development of treatment strategies. This article delves into two primary radiological investigations, chest X-rays and CT scans, outlining their purpose, procedures, and...
1.2K
Design of Transmission Shafts - Stress Analysis01:15

Design of Transmission Shafts - Stress Analysis

Designing a transmission shaft requires a thorough understanding of the stresses induced by bending moments and torques, especially in systems where power is transferred through gears. These forces create force-couple systems at the centers of the shaft's cross-sections, leading to both transverse and torsional loading. Although shearing stresses from transverse loads are typically smaller than those from torques and are often overlooked, the significant normal stresses from these loads...
746
Group Design02:01

Group Design

The most basic experimental design involves two groups: the experimental group and the control group. The two groups are designed to be the same except for one difference— experimental manipulation. The experimental group gets the experimental manipulation—that is, the treatment or variable being tested—and the control group does not. Since experimental manipulation is the only difference between the experimental and control groups, we can be sure that any differences between...
10.6K
Factorial Design02:01

Factorial Design

Factorial Analysis is an experimental design that applies Analysis of Variance (ANOVA) statistical procedures to examine a change in a dependent variable due to more than one independent variable, also known as factors. Changes in worker productivity can be reasoned, for example, to be influenced by salary and other conditions, such as skill level. One way to test this hypothesis is by categorizing salary into three levels (low, moderate, and high) and skills sets into two levels (entry level...
13.9K
Statistical Software for Data Analysis and Clinical Trials01:12

Statistical Software for Data Analysis and Clinical Trials

Statistical software is pivotal in data analysis and clinical trials by providing tools to analyze data, draw conclusions, and make predictions. These software packages range from simple data management applications to complex analytical platforms, supporting various statistical tests, models, and simulation techniques. Their significance lies in their ability to handle vast amounts of data with precision and efficiency, enabling researchers to validate hypotheses, identify trends, and make...
1.6K