Related Experiment Video
Updated: Feb 6, 2026
Detection and Removal of Tooth-Colored Composite Resin Using the Fluorescence-Aided Identification Technique
Published on: July 27, 2022
The Effects of Different Spectrophotometric Modes on Colour Measurement of Resin Composite and Porcelain Materials
N Alghazali1, A Preston1, M Moaleem2
1Liverpool University.
Objectives:
To investigate the influence of a number of controlled modes on the spectrophotometric analysis of the colour of resin composite and porcelain materials.
Methods:
A total of 20 samples of commercially available resin composite, and 20 samples of commercially available porcelain materials in four different shades were produced (five samples for each shade). Colour was measured using a spectrophotometer (CM2600-d, Minolta Konica) set with different colour measuring modes namely, small aperture size (SAV) or large aperture size (MAV); specular component included (SCI), or excluded (SCE); 0% (UV-) or 100% UV illumination (UV+). Colour data were then compared using paired T-test.
Results:
Colour coordinates measured with spectrophotometric modes set as 2° observation angle, SAV, SCI, and UV- were significantly different from those measured with 10° observation angle, MAV, SCE, and UV+ respectively in most cases for both materials.
Conclusion:
Different spectrophotometric modes (2 or 10 degrees observation angle, SAV or MAV aperture size, 0% or 100% UV, and SCI or SCE) significantly influenced the absolute colour measurements of resin composite and porcelain samples.
Clinical Significance:
Measuring modes should be taken into consideration when comparing the results of absolute colour measurements of resin composite and dental porcelain materials.
More Related Videos
09:38Strain Sensing Based on Multiscale Composite Materials Reinforced with Graphene Nanoplatelets
Published on: November 7, 2016
06:26Experimental Implementation of a New Composite Fabrication Method: Exposing Bare Fibers on the Composite Surface by the Soft Layer Method
Published on: October 6, 2017
Related Concept Videos
01:07What is a Mode?
There can be more than one mode in a data set if multiple values have the same highest frequency. For instance, suppose that the Statistics exam scores of 20 students are: 50; 53; 59; 59; 63; 63; 72; 72; 72; 72; 72; 76; 78; 81; 83; 84; 84; 84; 90; 93. Here, the mode is 72, as it occurs most frequently, five times.
A data set with two modes is called bimodal. For example,...
03:35Classifying Matter by Composition
According to its composition, the matter can be classified into two broad categories — pure substances and mixtures.
A pure substance is a form of matter that has a constant composition throughout with uniform properties. For example, any sample of sucrose has the same composition and same physical properties, such as melting point, color, and sweetness, regardless of the source from which it is isolated.
A mixture is composed of two or...
01:14Ventilatory Modes
There are three ventilatory modes: full support, partial support, and spontaneous. These are described below.
Full Support Modes
Full support modes include controlled mechanical ventilation, continuous mandatory...
01:03Modes of Standing Waves - I
01:04Modes of Standing Waves: II
For a tube open at one end and closed at the other filled with air, the modes are such that there is always an antinode at the open end and a node at the closed end....
01:22MOSFET: Enhancement Mode
In their basic form, enhancement-mode MOSFETs are typically non-conductive when the gate-source voltage (Vgs) is zero. This default 'off' state means no...