Elongated Bouncing and Reduced Contact Time of a Drop in the Janus State

Venkataraman Sahoo1, Chu-Yao Chou1, Ching-Wen Lo1

  • 1Department of Mechanical Engineering , National Chiao Tung University , Hsinchu 30010 , Taiwan.

Related Concept Videos

Transcription Elongation Factors02:35

Transcription Elongation Factors

Transcription elongation is a dynamic process that alters depending upon the sequence heterogeneity of the DNA being transcribed. Hence, it is not surprising that the elongation complex's composition also varies along the way while transcribing a gene.
The transcription elongation is regulated via pausing of RNA polymerase on several occasions during transcription. In bacteria, these halts are necessary because the transcription of DNA into mRNA is coupled to the translation of that mRNA...
14.0K
Transcription Elongation Factors02:35

Transcription Elongation Factors

4.8K
Contact Angle01:13

Contact Angle

When a solid is dipped inside a liquid, the liquid surface becomes curved near the contact. For some solid–liquid interfaces, the liquid is pulled up along the solid, while for others, the liquid surface is convex or depressed near the solid surface. This phenomenon can be explained using the concept of cohesive and adhesive forces.
The adhesive force is the molecular force between molecules of different materials, that is, between the molecules of the solid and the liquid. The cohesive...
21.1K
Contact-dependent Signaling01:19

Contact-dependent Signaling

Contact-dependent signaling, as the name suggests, requires that communicating cells be in direct contact with each other. This is achieved either through receptor-ligand interactions or by specialized cytoplasmic channels that allow the flow of small molecules between cells. In animal cells, channels called gap junctions facilitate contact-dependent signaling in certain tissues, whereas, plasmodesmata perform a similar function in plants.
Gap Junctions
In animal cells, gap junctions are formed...
47.5K
Reducing Line Loss01:18

Reducing Line Loss

In a three-phase circuit, line loss is an indicator of energy dissipated as heat due to the resistance of transmission lines. To address this, incorporating transformers into the system—a step-up transformer at the source and a step-down transformer at the load—is a strategic solution. Two three-phase transformers are introduced to improve this.
With a step-up transformer at the source, the voltage is increased, thereby reducing the current in the transmission lines since power loss in...
390
Excess Pressure Inside a Drop and a Bubble01:13

Excess Pressure Inside a Drop and a Bubble

The shape of a small drop of liquid can be considered spherical, neglecting the effect of gravity. This drop can further be considered as two equal hemispherical drops put together due to surface tension. The forces acting on the spherical drop are due to the pressure of the liquid inside the drop, the pressure due to air outside the drop, and the force due to the surface tension acting on the two hemispherical drops.
3.5K