Corrigendum: Figure Correction. Primary Cilia as a Signaling Platform for Control of Energy Metabolism

In any measurement, the precision of the measuring tool is an essential factor. An ordinary ruler, for example, can measure length to the closest millimeter; a caliper, on the other hand, can measure length to the nearest 0.01 mm. As a result, the caliper is a more precise measurement tool because it can measure extremely minute changes in length. The measurements will be more accurate if the measuring tool is more precise.
It should be emphasized that when we represent measured values, the...

In an electrical system with a resistor, voltage and current signals facilitate the measurement of power and energy across the resistor. For a continuous-time signal, the total energy over a time interval is defined as the integral of the square of the signal's magnitude over that interval. Mathematically, this is expressed as:

All the digits in a measurement, including the uncertain last digit, are called significant figures or significant digits. Note that zero may be a measured value; for example, if a scale that shows weight to the nearest pound reads “140,” then the 1 (hundreds), 4 (tens), and 0 (ones) are all significant (measured) values.

Overview

Consider a turbine operating under steady-flow conditions. The control volume is drawn around the turbine, with fluid entering at one point and exiting at another. The turbine extracts energy from the fluid, which performs mechanical work (shaft work).
For steady flow systems, the time derivative of the stored energy becomes zero since there is no energy accumulation within the control volume. This simplifies the energy equation to:

Uncertainty in measurements can be avoided by reporting the results of a calculation with the correct number of significant figures. This can be determined by the following rules for rounding numbers: