Structure and mobility of actin filaments as measured by quasielastic light scattering, viscometry, and electron...

Actin filaments of different lengths were prepared by polymerizing actin in the presence of various concentrations of gelsolin, a protein which accelerates actin polymerization by stabilizing nuclei from which filaments grow and which binds to their fast growing ends. The lengths of the actin filaments following polymerization were measured by electron microscopy and showed that the number-average filament length agreed with the predicted length if each gelsolin molecule acted as a seed for the growth of an actin filament. The distribution of lengths was independent of the actin:gelsolin ratio and was similar to that of actin filaments polymerized in the absence of gelsolin (Lw/Ln = 1.8). The mobility of these filaments in solution was studied by quasielastic light scattering and by viscometry. The translational diffusion constant determined by quasielastic light scattering was in agreement with the infinite dilution values calculated from the dimensions and the distribution of lengths determined by electron microscopy for relatively short filament lengths. Under conditions where overlap of the rotational domains of the filaments would be expected to occur, the measured diffusion rates deviated from their predicted dilute solution values and the solution viscosity increased abruptly. The dependence of the diffusion constant and the solution viscosity on the length of the actin filaments can be explained in terms of a theory that describes the restraints on diffusion of independent rigid rods in semi-dilute solution. The results suggest that the rheology of actin filaments can be accounted for by steric restraints. The length of cytoplasmic actin filaments in some cell types is such that these steric constraints are significant and could produce large changes in physical properties with small changes in filament length.