Biological evaluations of newly-designed Pt(II) and Pd(II) complexes using spectroscopic and molecular docking

Behafarid Ghalandari1, Atefeh Poursoleiman2, Mina Fekri3

  • 1a Department of Medical Nanotechnology , Applied Biophotonics Research Center, Science and Research Branch, Islamic Azad University , Tehran , Iran.

Related Concept Videos

PD Controller: Design01:26

PD Controller: Design

In automotive engineering, car suspension systems often employ Proportional Derivative (PD) controllers to enhance performance. PD controllers are utilized to adjust the damping force in response to road conditions. A controller, acting as an amplifier with a constant gain, demonstrates proportional control, with output directly mirroring input.
Designing a continuous-data controller requires selecting and linking components like adders and integrators, which are fundamental in Proportional,...
658
Dosage Regimens: Designs and Approaches01:28

Dosage Regimens: Designs and Approaches

Designing a dosage regimen, which refers to the manner of drug administration, is a complex process involving the selection of drug dose, route, and frequency. This process is underpinned by pharmacokinetic parameters derived from tests and population averages. These parameters are then tailored to patient-specific variables such as diagnosis, demographics, and allergy status. Once therapy commences, therapeutic response monitoring is critical and achieved through clinical and physical...
322
Factorial Design02:01

Factorial Design

Factorial Analysis is an experimental design that applies Analysis of Variance (ANOVA) statistical procedures to examine a change in a dependent variable due to more than one independent variable, also known as factors. Changes in worker productivity can be reasoned, for example, to be influenced by salary and other conditions, such as skill level. One way to test this hypothesis is by categorizing salary into three levels (low, moderate, and high) and skills sets into two levels (entry level...
13.8K
Group Design02:01

Group Design

The most basic experimental design involves two groups: the experimental group and the control group. The two groups are designed to be the same except for one difference— experimental manipulation. The experimental group gets the experimental manipulation—that is, the treatment or variable being tested—and the control group does not. Since experimental manipulation is the only difference between the experimental and control groups, we can be sure that any differences between...
10.6K
Protein Complex Assembly02:41

Protein Complex Assembly

Proteins can form homomeric complexes with another unit of the same protein or heteromeric complexes with different types.  Most protein complexes self-assemble spontaneously via ordered pathways, while some proteins need assembly factors that guide their proper assembly. Despite the crowded intracellular environment, proteins usually interact with their correct partners and form functional complexes.
Many viruses self-assemble into a fully functional unit using the infected host cell to...
16.8K
Time-Domain Interpretation of PD Control01:07

Time-Domain Interpretation of PD Control

Proportional-Derivative (PD) control is a widely used control method in various engineering systems to enhance stability and performance. In a system with only proportional control, common issues include high maximum overshoot and oscillation, observed in both the error signal and its rate of change. This behavior can be divided into three distinct phases: initial overshoot, subsequent undershoot, and gradual stabilization.
Consider the example of control of motor torque. Initially, a positive...
408