Related Experiment Video
Updated: Feb 5, 2026

The Use of Thermal Infra-Red Imaging to Detect Delayed Onset Muscle Soreness
Published on: January 22, 2012
Constraints on the onset duration of the Paleocene-Eocene Thermal Maximum
1Department of Earth Sciences, University of California, Riverside, CA 92521, USA sandra.kirtlandturner@ucr.edu.
Abstract:
The Paleocene-Eocene Thermal Maximum (PETM, approx. 56 Ma) provides a test case for investigating how the Earth system responds to rapid greenhouse gas-driven warming. However, current rates of carbon emissions are approximately 10 Pg C yr-1, whereas those proposed for the PETM span orders of magnitude-from ≪1 Pg C yr-1 to greater than the anthropogenic rate. Emissions rate estimates for the PETM are hampered by uncertainty over the total mass of PETM carbon released as well as the PETM onset duration. Here, I review constraints on the onset duration of the carbon isotope excursion (CIE) that is characteristic of the event with a focus on carbon cycle model-based attempts that forgo the need for a traditional sedimentary age model. I also review and compare existing PETM carbon input scenarios employing the Earth system model cGENIE and suggest another possibility-that abrupt input of an isotopically depleted carbon source combined with elevated volcanic outgassing over a longer interval can together account for key features of the PETM CIE.This article is part of a discussion meeting issue 'Hyperthermals: rapid and extreme global warming in our geological past'.
Related Concept Videos
Maximum Deflection
The maximum deflection occurs at a specific point, known as point O, where the tangent to the deflection curve is horizontal. To find point O, the slope of the tangent at any...
Constraints and Statical Determinacy
Maximum Power Transfer
By substituting the entire circuit with...
Maximum Size of Aggregate
The Maximum Power Transfer Theorem
The load connected draws the current, and the circuit delivers the power to the load. The alternating current flowing through the load is determined using the rectangular form of voltages, currents, network impedance, and load impedance. The average power delivered to the load is obtained from the product of the square of current and load resistance.
Maximum Power Flow and Line Loadability

