Difference scores between single-task and dual-task gait measures are better than clinical measures for detection of

D Commandeur1, M D Klimstra1, S MacDonald2

  • 1Motion and Mobility Rehabilitation Laboratory, University of Victoria, Canada; School of Exercise Science, Physical and Health Education, University of Victoria, Canada.

Gait & Posture
|September 9, 2018
PubMed
Abstract

Related Concept Videos

Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
8.4K
Measures of Central Tendency02:16

Measures of Central Tendency

The "center" of a data set is also a way of describing location. The two most widely used measures of the "center" of the data are the mean (average) and the median. The words "mean" and "average" are often used interchangeably. The substitution of one word for the other is common practice. The technical term is "arithmetic mean" and "average" is technically a center location. However, in practice among non-statisticians,...
21.2K
What are Populations and Communities?00:30

What are Populations and Communities?

Overview
37.9K
Definition and Measurement of Pressure: Atmospheric Pressure, Barometer, and Manometer02:57

Definition and Measurement of Pressure: Atmospheric Pressure, Barometer, and Manometer

Gas pressure is caused by force exerted by gas molecules colliding with the surfaces of objects. Although the force of each collision is very small, any surface of an appreciable area experiences a large number of collisions in a short time, which can result in high pressure.
43.5K
Uncertainty in Measurement: Accuracy and Precision03:37

Uncertainty in Measurement: Accuracy and Precision

Scientists typically make repeated measurements of a quantity to ensure the quality of their findings and to evaluate both the precision and the accuracy of their results. Measurements are said to be precise if they yield very similar results when repeated in the same manner. A measurement is considered accurate if it yields a result that is very close to the true or the accepted value. Precise values agree with each other; accurate values agree with a true value. 
102.4K
Free-falling Bodies: Example01:05

Free-falling Bodies: Example

An object falling without any air resistance under the influence of gravitational force is said to be in free-fall. For free-falling bodies, the acceleration due to gravity is constant, irrespective of their mass. Free-fall is experienced not only by objects falling downward, but also by all objects whose motion is influenced by gravitational force alone. The dynamics of free-fall motion can be calculated using kinematic equations of motion, since free-fall acceleration is constant.
The...
32.1K