4-Phenyl-1,3-thiazole-2-amines as scaffolds for new antileishmanial agents

Carina Agostinho Rodrigues1, Paloma Freire Dos Santos1, Marcela Oliveira Legramanti da Costa1

  • 11Chemical and Pharmaceutical Research Group, Department of Pharmaceutical Sciences, Institute of Environmental, Chemical and Pharmaceutical Sciences, Federal University of São Paulo (UNIFESP), Rua São Nicolau, 210, 2o andar, Diadema, SP 09913-030 Brazil.

Abstract

Related Concept Videos

Nitriles to Amines: LiAlH4 Reduction00:55

Nitriles to Amines: LiAlH4 Reduction

Nitriles are reduced to amines in the presence of strong reducing agents like lithium aluminum hydride through a typical nucleophilic acyl substitution. The reaction requires two equivalents of the reducing agent. The reducing agent acts as a source of hydride ions.
As shown below, the mechanism involves three steps. Firstly, the hydride ion acting as a nucleophile attacks the nitrile carbon to form an anion. In the second step, a second equivalent of the hydride ion attacks the anion to...
4.7K
Amides to Amines: LiAlH4 Reduction01:20

Amides to Amines: LiAlH4 Reduction

Amide reduction with strong reducing agents like lithium aluminum hydride proceeds through a nucleophilic acyl substitution to form amines. Primary, secondary, and tertiary amides yield primary, secondary, and tertiary amines, respectively.
Amide reduction requires two equivalents of the reducing agent, acting as a source of hydride ions. As shown in the figure, the reaction is initiated with a nucleophilic attack by the hydride ion at the carbonyl carbon to form a tetrahedral intermediate.
6.3K
2° Amines to N-Nitrosamines: Reaction with NaNO201:20

2° Amines to N-Nitrosamines: Reaction with NaNO2

Secondary amines react with nitrous acid to form N-nitrosamines, as depicted in Figure 1. Nitrous acid, a weak and unstable acid, is formed in situ from an aqueous solution of sodium nitrite and strong acids, such as hydrochloric acid or sulfuric acid, in cold conditions. In the presence of an acid, the nitrous acid gets protonated. The subsequent loss of water results in the formation of the electrophile known as nitrosonium ion.
5.5K
Electrophilic 1,2- and 1,4-Addition of X2 to 1,3-Butadiene01:14

Electrophilic 1,2- and 1,4-Addition of X2 to 1,3-Butadiene

Electrophilic addition of halogens to alkenes proceeds via a cyclic halonium ion to form a 1,2-dihalide or a vicinal dihalide.
3.6K
Criteria for Aromaticity and the Hückel 4n + 2 Rule01:20

Criteria for Aromaticity and the Hückel 4n + 2 Rule

Like benzene, cyclobutadiene and cyclooctatetraene are cyclic compounds with alternate single and double bonds. However, their chemical behavior differs from benzene, as they are unstable and not aromatic. So, what are the structural characteristics of unsaturated compounds categorized as aromatic?  
For the first time, Eric Hückel, a German chemical physicist, derived a set of structural features for a compound to be classified as aromatic. This is now known as Hückel’s rule or the 4n +...
13.3K
[4+2] Cycloaddition of Conjugated Dienes: Diels–Alder Reaction01:16

[4+2] Cycloaddition of Conjugated Dienes: Diels–Alder Reaction

The Diels–Alder reaction is an example of a thermal pericyclic reaction between a conjugated diene and an alkene or alkyne, commonly referred to as a dienophile. The reaction involves a concerted movement of six π electrons, four from the diene and two from the dienophile, forming an unsaturated six-membered ring. As a result, these reactions are classified as [4+2] cycloadditions.
12.4K