Trophic Strategies Influence Metal Bioaccumulation in Detritus-Based, Aquatic Food Webs

Nathan J Tomczyk1,2, Thomas B Parr3, Elmer Gray4

  • 1Odum School of Ecology , University of Georgia , Athens , Georgia United States.

Related Concept Videos

Metal-Ligand Bonds02:51

Metal-Ligand Bonds

The hemoglobin in the blood, the chlorophyll in green plants, vitamin B-12, and the catalyst used in the manufacture of polyethylene all contain coordination compounds. Ions of the metals, especially the transition metals, are likely to form complexes.
In these complexes, transition metals form coordinate covalent bonds, a kind of Lewis acid-base interaction in which both of the electrons in the bond are contributed by a donor (Lewis base) to an electron acceptor (Lewis acid). The Lewis acid in...
24.3K
Trophic Levels01:35

Trophic Levels

All organisms in an ecosystem occupy a trophic level in the food chain. The lowest level consists of primary producers, which synthesize their food from either solar or chemical energy. Each subsequent level obtains energy from the levels below. Detritivores can occupy any of the levels above primary producers.
37.6K
Trophic Efficiency00:46

Trophic Efficiency

Trophic level transfer efficiency (TLTE) is a measure of the total energy transfer from one trophic level to the next. Due to extensive energy loss as metabolic heat, an average of only 10% of the original energy obtained is passed on to the next level. This pattern of energy loss severely limits the possible number of trophic levels in a food chain.
25.2K
Alkali Metals03:06

Alkali Metals

Group 1 elements are soft and shiny metallic solids. They are malleable, ductile, and good conductors of heat and electricity. The melting points of the alkali metals are unusually low for metals and decrease going down the group, while the density increases going down the group with the exception of potassium (Table 1).
Table 1: Properties of the alkali metals
24.8K
Properties of Transition Metals02:58

Properties of Transition Metals

Transition metals are defined as those elements that have partially filled d orbitals. As shown in Figure 1, the d-block elements in groups 3–12 are transition elements. The f-block elements, also called inner transition metals (the lanthanides and actinides), also meet this criterion because the d orbital is partially occupied before the f orbitals.
29.9K
Bonding in Metals02:32

Bonding in Metals

Metallic bonds are formed between two metal atoms. A simplified model to describe metallic bonding has been developed by Paul Drüde called the “Electron Sea Model”. 
52.5K