Analysis of running stability during 5000 m running

Related Experiment Video

Updated: Feb 4, 2026

Tracking Individual Running Metrics in Mice Using a Voluntary Wheel Running Protocol that Minimizes Social Isolation
04:48

Tracking Individual Running Metrics in Mice Using a Voluntary Wheel Running Protocol that Minimizes Social Isolation

Published on: April 18, 2025

1.1K

Tim Hoenig1, Daniel Hamacher2, Klaus-Michael Braumann1

  • 1a Department of Sports and Exercise Medicine, Institute of Human Movement Science , University of Hamburg , Hamburg , Germany.

European Journal of Sport Science
|September 27, 2018
PubMed

Keywords:
Local dynamic stabilityLyapunov exponentbiomechanicsfatigue

More Related Videos

Recording and Analysis of Circadian Rhythms in Running-wheel Activity in Rodents05:46

Recording and Analysis of Circadian Rhythms in Running-wheel Activity in Rodents

Published on: January 24, 2013

22.1K
Influence of Step-Width Manipulation on Running Biomechanics06:53

Influence of Step-Width Manipulation on Running Biomechanics

Published on: February 28, 2025

1.0K

Related Concept Videos

Wald-Wolfowitz Runs Test II01:17

Wald-Wolfowitz Runs Test II

The Wald-Wolfowitz runs test, commonly referred to as the runs test, is a nonparametric test used to assess the randomness of ordered data. The test evaluates the number of runs, which are consecutive sequences of similar elements within the data. If the number of runs is significantly higher or lower than expected, the data is considered non-random, indicating a detectable pattern or structure.
For binary data, runs are identified using symbols such as + and −, or equivalently, 1s and 0s. In...
551
Wald-Wolfowitz Runs Test I01:17

Wald-Wolfowitz Runs Test I

The Wald-Wolfowitz test, also known as the runs test, is a nonparametric statistical test used to assess the randomness of a sequence of two different types of elements (e.g., positive/negative values, successes/failures). It examines whether the order of the elements in a sequence is random or if there is a pattern or trend present. This nonparametric test applies to any ordered data despite the population and sample data distribution, even if a higher sample size is available.
The test works...
963
RNA Stability01:53

RNA Stability

Intact DNA strands can be found in fossils, while scientists sometimes struggle to keep RNA intact under laboratory conditions. The structural variations between RNA and DNA underlie the differences in their stability and longevity. Because DNA is double-stranded, it is inherently more stable. The single-stranded structure of RNA is less stable but also more flexible and can form weak internal bonds. Additionally, most RNAs in the cell are relatively short, while DNA can be up to 250 million...
35.7K
Nuclear Stability03:18

Nuclear Stability

Protons and neutrons, collectively called nucleons, are packed together tightly in a nucleus. With a radius of about 10−15 meters, a nucleus is quite small compared to the radius of the entire atom, which is about 10−10 meters. Nuclei are extremely dense compared to bulk matter, averaging 1.8 × 1014 grams per cubic centimeter. If the earth’s density were equal to the average nuclear density, the earth’s radius would be only about 200 meters.
To hold positively charged protons together...
23.3K
Stability01:28

Stability

The time response of a linear time-invariant (LTI) system can be divided into transient and steady-state responses. The transient response represents the system's initial reaction to a change in input and diminishes to zero over time. In contrast, the steady-state response is the behavior that persists after the transient effects have faded.
The stability of an LTI system is determined by the roots of its characteristic equation, known as poles. A system is stable if it produces a bounded...
418
Stability of structures01:14

Stability of structures

In mechanical engineering, the stability of systems under various forces is critical for designing durable and efficient structures. One fundamental way to explore these concepts is by analyzing systems like two rods connected at a pivot point, O, with a torsional spring of spring constant k at the pivot point. This system is similar in appearance to a scissor jack used to change tires on a car. In this case, the arms of the linkage (equivalent to the rods in this system) are entirely vertical,...
525