Intraosseous pressure during loading and with vascular occlusion in an animal model

M Beverly1, S Mellon1, J A Kennedy1

  • 1Nuffield Department of Orthopaedics, Rheumatology and Musculoskeletal Sciences, University of Oxford, Botnar Research Centre, Nuffield Orthopaedic Centre, Oxford, UK.

Bone & Joint Research
|September 28, 2018
PubMed
Abstract

Related Concept Videos

Seedless Vascular Plants03:24

Seedless Vascular Plants

Seedless Vascular Plants Were the First Tall Plants on Earth
67.0K
Vapor Pressure02:34

Vapor Pressure

When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase molecules move randomly about, they will occasionally collide with the surface of the condensed phase, and in some cases, these collisions will result in the molecules re-entering the condensed phase. The change from the gas phase to the liquid is called condensation. When the rate of condensation becomes equal to the rate of vaporization, neither the amount of the liquid nor the amount of the vapor...
40.8K
Definition and Measurement of Pressure: Atmospheric Pressure, Barometer, and Manometer02:57

Definition and Measurement of Pressure: Atmospheric Pressure, Barometer, and Manometer

Gas pressure is caused by force exerted by gas molecules colliding with the surfaces of objects. Although the force of each collision is very small, any surface of an appreciable area experiences a large number of collisions in a short time, which can result in high pressure.
43.4K
Impact Loading01:19

Impact Loading

Impact loading occurs when a moving object collides with a stationary structure, such as a rod with a uniform cross-sectional area fixed at one end. Under these conditions, the rod absorbs the kinetic energy from the striking object, leading to deformation and subsequent stress development. As the rod returns to its original position and reaches maximum stress, the absorbed energy, initially manifested as kinetic energy, transforms entirely into strain energy.
In cases of elastic deformation,...
701
Tonicity in Animals00:59

Tonicity in Animals

The tonicity of a solution determines if a cell gains or loses water in that solution. The tonicity depends on the permeability of the cell membrane for different solutes and the concentration of nonpenetrating solutes in the solution within and outside of the cell. If a semipermeable membrane hinders the passage of some solutes but allows water to follow its concentration gradient, water moves from the side with low osmolarity (i.e., less solute) to the side with higher osmolarity (i.e.,...
124.5K
Tonicity in Animals01:16

Tonicity in Animals

Tonicity describes the amount of solute in a solution. The measure of the tonicity of a solution, or the total amount of solutes dissolved in a specific amount of solution, is called its osmolarity. Three terms—hypotonic, isotonic, and hypertonic—are used to relate the osmolarity of a cell to the osmolarity of the extracellular fluid that contains the cells. In a hypotonic solution, such as tap water, the extracellular fluid has a lower concentration of solutes than the fluid inside...
5.3K