Related Experiment Video
Updated: Feb 4, 2026

In vitro Methylation Assay to Study Protein Arginine Methylation
Published on: October 5, 2014
Experimental study of methyl tert-butyl ether as an oxygenated additive in diesel and Calophyllum inophyllum methyl
Ashok Bragadeshwaran1, Nanthagopal Kasianantham2, Saravanan Ballusamy3
1School of Mechanical Engineering, VIT University, Vellore, 632014, India.
Abstract:
This work presents the effect of the ternary oxygenated additive on diesel biodiesel blended fuel to evaluate the engine characteristics. The Calophyllum inophyllum trees being abundant in India can lessen the dependence on petroleum imports to a specific extent. Methyl tertiary butyl ether is used as an oxygenated additive for the ternary blends preparation as 5-20% by volume. Seven blends of neat baseline diesel, biodiesel (Calophyllum inophyllum Methyl Ester), a blend of diesel (50%)-biodiesel (50%), a blend of diesel (50%)-biodiesel-methyl tert-butyl ether (5, 10, 15, and 20%) are prepared which are tested on a single cylinder, constant speed diesel engine. The experimental results were revealed that the replacement of biodiesel by MTBE has shown a slight reduction in brake thermal efficiency with a slight increase in brake-specific fuel consumption. Further, the MTBE addition in ternary blends reduced the unburned hydrocarbon, CO, and NOx by 63.9, 6.4, and 3.37% respectively. In addition, the carbon dioxide emission is almost similar to diesel fuel at a higher addition of MTBE with diesel-biodiesel blend. In the combustion point of view, the addition of 5% MTBE resulted in 3.49 and 5.1% reduction of peak pressure and heat release rate are observed as compared to diesel fuel. Critical analysis in combustion aspects is also carried out and it is witnessed with prolonged ignition delay during MTBE addition with diesel-biodiesel blends.
Related Concept Videos
Phase II Reactions: Methylation Reactions
The mechanism of methylation unfolds in two stages. The first stage sees a methyltransferase enzyme facilitating the transfer of a methyl group from S-adenosylmethionine (SAM) to the substrate, forming S-adenosylhomocysteine (SAH). The second stage involves further metabolism of SAH into homocysteine, which can be recycled...
Ethers from Alkenes: Alcohol Addition and Alkoxymercuration-Demercuration
Ethers can also be prepared from alkenes through acid-catalyzed addition of alcohols and alkoxymercuration–demercuration.
Preparation of Ethers by Acid-Catalyzed Addition of Alcohol to Alkenes
The acid-catalyzed addition of alcohol to an alkene involves treating the alkene with an excess of alcohol in the presence of an acid catalyst to form an ether under suitable conditions. The hydrogen will add to the less substituted carbon so that the nucleophile can attack the more substituted...
Multiple Halogenation of Methyl Ketones: Haloform Reaction
Batteries and Fuel Cells
Otto and Diesel Cycle
Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis
Ethers can be prepared from organic compounds by various methods. Some of them are discussed below,
Preparation of Ethers by Alcohol Dehydration
In this method, in the presence of protic acids, alcohol dehydrates to produce alkenes and ethers under different conditions. For example, in the presence of sulphuric acid, dehydration of ethanol at 413 K yields ethoxyethane, whereas it yields ethene at 443 K.

