Related Experiment Video
Updated: Feb 4, 2026

Silicon Metal-oxide-semiconductor Quantum Dots for Single-electron Pumping
Published on: June 3, 2015
Pump wavelength dependence of ASE and SBS in single-frequency EYDFAs
Abstract:
In this Letter, the pump wavelength dependence of the amplified spontaneous emission (ASE) and the threshold of stimulated Brillouin scattering (SBS) in a typical single-frequency continuous wave Er3+:Yb3+-codoped fiber amplifier is investigated numerically. The Er3+:Yb3+ system is modeled as coupled two- and three-level systems, linked by a Förster resonance energy transfer process and described by the corresponding rate equations. The evolution of the pump and signal power along the fiber is modeled by differential equations, taking into account the steady-state population densities. Since the absorption at 976 nm can exceed the Yb3+-to-Er3+ energy transfer rate in high-power operation, unsaturated gain at around 1.0 μm can generate excessive ASE. Off-peak pumping with commercially available pump diodes at 915 or 940 nm spatially distributes the energy over a longer distance. For the studied amplifier configuration, energy transfer bottlenecking is prevented without the onset of SBS.
Related Concept Videos
Frequency-dependent Selection
The de Broglie Wavelength
ATP Driven Pumps III: V-type Pumps
The peripheral or cytosolic V1 domain with eight subunits is involved in ATP hydrolysis. The integral or transmembrane V0 domain containing at least five subunits...
ATP Driven Pumps II: P-type Pumps
A typical P-type pump has three cytosolic domains: nucleotide-binding (N), phosphorylation (P), and activator (A) domains. These domains are connected to the membrane-spanning helices by short amino acid segments. ATP hydrolysis and covalent phosphoenzyme intermediate formation are crucial parts of the catalytic cycle. At the highly...
Pumped Concrete
For direct-acting pumps, the concrete enters the pump via the inlet valve under the action of gravity and suction created by the movement of the piston. This concrete is then forced into the pipeline and out through the outlet valve by the forward movement...
Temperature Dependence on Reaction Rate
Atoms, molecules, or ions must collide before they can react with each other. Atoms must be close together to form chemical bonds. This premise is the basis for a theory that explains many observations regarding chemical kinetics, including factors affecting reaction rates.
The collision theory is based on the postulates that (i) the reaction rate is proportional to the rate of reactant collisions, (ii) the reacting species collide in an orientation allowing contact between...

