Related Experiment Video

Updated: Feb 4, 2026

Engineering Antiviral Agents via Surface Plasmon Resonance
13:00

Engineering Antiviral Agents via Surface Plasmon Resonance

Published on: June 14, 2022

2.8K

Optical Micro/Nanofiber-Based Localized Surface Plasmon Resonance Biosensors: Fiber Diameter Dependence

Kaiwei Li1, Wenchao Zhou2, Shuwen Zeng3

  • 1Guangdong Key Laboratory of Optical Fiber Sensing and Communications, Institute of Photonics Technology, Jinan University, Guangzhou 510632, China. likaiwei11@163.com.

Sensors (Basel, Switzerland)
|October 3, 2018
PubMed

Keywords:
fiber optic biosensorlocalized surface plasmon resonanceoptical micro/nanofiber

More Related Videos

Electrospun Nanofiber Scaffolds with Gradations in Fiber Organization09:32

Electrospun Nanofiber Scaffolds with Gradations in Fiber Organization

Published on: April 19, 2015

10.3K
Detection of Toxin Translocation into the Host Cytosol by Surface Plasmon Resonance10:41

Detection of Toxin Translocation into the Host Cytosol by Surface Plasmon Resonance

Published on: January 3, 2012

13.8K

Related Concept Videos

Resonance02:52

Resonance

The Lewis structure of a nitrite anion (NO2−) may actually be drawn in two different ways, distinguished by the locations of the N-O and N=O bonds.
65.6K
Local Anesthetics: Differential Sensitivity of Nerve Fibers01:24

Local Anesthetics: Differential Sensitivity of Nerve Fibers

Local anesthetics (LAs) block the sodium channels of nerve trunks, sensory nerve endings, and neuromuscular junctions. Although LAs can block all kinds of nerves, the sensitivity of nerve fibers differs according to nerve types and structures. LAs are known to block myelinated fibers faster than unmyelinated ones. Also, they block pain or sensory neurons at low concentrations without affecting the motor neurons involved in muscle contractions. This helps relieve labor pain without affecting the...
1.5K
Classification of Skeletal Muscle Fibers01:48

Classification of Skeletal Muscle Fibers

Skeletal muscles continuously produce ATP to provide the energy that enables muscle contractions. Skeletal muscle fibers can be categorized into three types based on differences in their contraction speed and how they produce ATP, as well as physical differences related to these factors. Most human muscles contain all three muscle fiber types, albeit in varying proportions.
Slow-Twitch Muscle Fibers
Slow oxidative, muscle fibers appear red due to large numbers of capillaries and high levels of...
59.5K
Local Anesthetics: Clinical Application as Surface, Infiltration, and Conduction Block Anesthesia01:30

Local Anesthetics: Clinical Application as Surface, Infiltration, and Conduction Block Anesthesia

Depending on the target organ, local anesthetics (LAs) can be administered via various routes. In surface anesthesia, LAs are applied directly to the surface of the skin or mucous membranes. It is widely used for topical skin numbing before venipuncture or minor surgical procedures. Commonly used surface local anesthetics are lidocaine or benzocaine sprays or creams. Surface anesthesia occurs within 5 minutes and lasts for about 60 minutes. One of the main disadvantages of topical anesthesia is...
2.1K
Frequency-dependent Selection01:21

Frequency-dependent Selection

When the fitness of a trait is influenced by how common it is (i.e., its frequency) relative to different traits within a population, this is referred to as frequency-dependent selection. Frequency-dependent selection may occur between species or within a single species. This type of selection can either be positive—with more common phenotypes having higher fitness—or negative, with rarer phenotypes conferring increased fitness.
24.1K
Design Example: Calculating Safe Diameter for Wind-Exposed Disc01:17

Design Example: Calculating Safe Diameter for Wind-Exposed Disc

Assessing safety in wind-exposed installations is crucial to preventing potential failures. This example explores the calculation and design adjustments needed to mount a circular disc on a building facade, where wind forces are a primary concern. A 4-meter diameter disc was initially designed as an aesthetic feature facing winds at a velocity of 25 meters per second, with an air density of 1.25 kilograms per cubic meter. Given these conditions, the drag force on the disc was determined using...
359