A fluorometric aptasensor for patulin based on the use of magnetized graphene oxide and DNase I-assisted target...

A fluorometric patulin (PAT) assay is presented that is based on the use of magnetic reduced graphene oxide (rGO) and DNase I. The fluorescence of the PAT aptamer labelled with 6-carboxyfluorescein (FAM) is quenched by magnetized reduced graphene oxide (rGO-Fe₃O₄) due to fluorescence resonance energy transfer (FRET). However, in the presence of PAT, the labelled aptamer is stripped off from rGO-Fe₃O₄. The rGO-Fe₃O₄ is then magnetically separated so that the fluorescence of free labelled PAT aptamer is restored. DNase I cannot hydrolyze the aptamer on rGO-Fe₃O₄, but it can cleave the free aptamer-PAT complex. This will release FAM and PAT which can undergo a number of additional cycles to trigger the cleavage of abundant aptamer. Recycling of DNase I-assisted target therefore leads to a strong amplification of fluorescence and consequently to an assay with low limit of detection. The detection limit for PAT is as low as 0.28 μg L^-1 which is about 13 times lower than that without using DNase I. The method offers a new approach towards rapid, sensitive and selective detection based on an aptamer. Conceivably, it has a wide scope in that it may be applied to numerous other analytes if appropriate aptamers are available. Abstract Schematic of a fluorometric assay based on the use of magnetic graphene oxide and DNase I. It was applied to the determination of patulin. DNase I was introduced for recycling amplification. The detection limit is about 13 times lower than that without using DNase I. Figure a contains poor quality of text in image. Otherwise, please provide replacement figure file.Thank you. I will provide the figure file.