Related Experiment Video
Updated: Feb 3, 2026

'Boden Food Plate': Novel Interactive Web-based Method for the Assessment of Dietary Intake
Published on: September 18, 2018
Accuracy of a Nutrient Database in Estimating the Dietary Phosphorus-to-Protein Ratio and Using a Boiling Method in
Wan-Chuan Tsai1,2,3, Yu-Sen Peng1,4,5, Hon-Yen Wu1,2,4,5
1Department of Internal Medicine, Far Eastern Memorial Hospital, New Taipei City, Taiwan.
Abstract:
The use of the dietary phosphorus-to-protein ratio (PPR) to reduce dietary phosphorus while maintaining protein intake is valuable for nutritional management in the dialysis population, but the actual PPR values in hospital meals have not been determined. We aimed to determine the accuracy of a nutrient database for estimating the PPR in low-phosphate hospital diets compared with the accuracy of chemical analysis and produce hospital diets with low-phosphate content by boiling meat for 30 minutes before cooking. The phosphorus and protein content of 26 cooked dishes selected from the hospital menu was estimated using a food composition table (FCT) and sent for chemical analysis. Comparisons of FCT-based estimated values with measured values for every 100 g of tested foods revealed an overestimation for the PPR both in plant-based dishes (mean difference ± SD, 4.1 ± 14.6 mg/g, P = 0.06), and in meats (2.1 ± 2.3 mg/g, P = 0.06). By boiling meats, we crafted diets with PPR as low as 8 mg/g. Caution should be exercised in estimating the PPR using a FCT in hospital diets and boiling should be used to prepare hospital meals. Such diets will be promoted for dialysis patients in both inpatient and outpatient settings.
Related Concept Videos
Hospitals-II
Nurses that work in...
Proteins: Dietary Sources and Requirements
Hospitals-I
The Phosphorus Cycle
Freezing Point Depression and Boiling Point Elevation
The boiling point of a liquid is the temperature at which its vapor pressure is equal to ambient atmospheric pressure. Since the vapor pressure of a solution is lowered due to the presence of nonvolatile solutes, it stands to reason that the solution’s boiling point will subsequently be increased. Vapor pressure increases with temperature, and so a solution will require a higher temperature than will pure solvent to achieve any given vapor pressure, including one...
Improving Translational Accuracy

