Single Intrauterine Death in Twins: The Importance of Fetal Order

Penelope L Ward1, Karen L Reidy2, Ricardo Palma-Dias2

  • 1University of Melbourne,Faculty of Medicine,Dentistry and Health Sciences,Melbourne,Victoria,Australia.

Related Concept Videos

Fetal Circulation01:14

Fetal Circulation

Fetal circulation is a unique system that facilitates the exchange of gases, nutrients, and waste products between the developing fetus and the mother. This intricate process takes place through a special organ called the placenta.
Two umbilical arteries transport blood from the fetus to the placenta. At the placenta, the blood absorbs oxygen and nutrients while simultaneously eliminating waste products. This oxygen-enriched and nutrient-rich blood then returns to the fetus through one...
3.0K
Autophagic Cell Death01:18

Autophagic Cell Death

Christian de Duve discovered “autophagy,” a process in which cellular components are engulfed by membrane-bound organelles called autophagosomes. The autophagosomes then fuse with lysosomes to digest the enclosed contents. Autophagy is generally activated in cells to prevent cell death. However, cell death is triggered when the damage is beyond repair.
Autophagy and Apoptosis
Autophagy can activate apoptosis. In normal conditions, the autophagy activating protein Beclin-1 and...
4.5K
Overview of Cell Death01:30

Overview of Cell Death

Cell death is an essential process where the body gets rid of old or damaged cells. Cell proliferation and death need to be balanced, as an imbalance between the two may lead to cancer or autoimmune diseases.
Cell death was observed in the early 19th century, but there was no experimental evidence to prove it. In 1842, Carl Vogt first discovered cell death in a metamorphic toad; however, it was not termed ‘cell death.’ Scientists discovered different cell death pathways only in the...
9.9K
Load along a Single Axis01:29

Load along a Single Axis

In structural engineering, the analysis of beams subjected to varying loads is a critical aspect of understanding the behavior and performance of these structural elements. A common scenario involves a beam subjected to a combination of different load distributions.
Consider a beam of length L subjected to a varying load, which is a combination of parabolic and trapezoidal load distribution along the x-axis. In this case, it is essential to determine the resultant loads, their locations, and...
646
Single Pipe Systems01:24

Single Pipe Systems

In pipe flow analysis, problems are typically categorized into three types — Type I, Type II, and Type III — based on the known parameters and the desired outcome. Each type of problem addresses specific engineering requirements using fluid properties, pipe characteristics, and operational conditions.
In a Type I problem, fluid properties (density and viscosity), pipe characteristics (including diameter, length, and surface roughness), and the flow rate or average velocity are...
454
Angular Momentum: Single Particle01:10

Angular Momentum: Single Particle

Angular momentum is directed perpendicular to the plane of the rotation, and its magnitude depends on the choice of the origin. The perpendicular vector joining the linear momentum vector of an object to the origin is called the “lever arm.” If the lever arm and linear momentum are collinear, then the magnitude of the angular momentum is zero. Therefore, in this case, the object rotates about the origin such that it lies on the rim of the circumference defined by the lever arm...
7.8K