Related Experiment Video
Updated: Feb 3, 2026
Detection and Removal of Tooth-Colored Composite Resin Using the Fluorescence-Aided Identification Technique
Published on: July 27, 2022
Assessing the effect of multibracket appliance treatment on tooth color by using electronic measurement
Anja Ratzmann1, Christan Schwahn2, Anja Treichel3
1Department of Orthodontics and Department of Dental Propaedeutics/Community Dentistry, Dental School, University Medicine, Walther-Rathenau Straße 42a, 17475, Greifswald, Germany. anja.ratzmann@uni-greifswald.de.
Background:
The purpose of this study was to investigate how tooth color is affected by multibracket appliance (MBA) treatment.
Methods:
The color of teeth #14 to #24 of 15 patients with MBA was measured on body and gingival tooth segments using the spectrophotometer Shade Inspector™. Colors of both segments were recorded before start of MBA treatment (baseline T0), end of MBA treatment (T1; 2 years ±0.3), and 3 months after T1 (T2). A 2D color system and a 3D system served as reference systems. Multilevel models were used to analyze color change within segments and to compare the difference in color change between segments (treatment effect).
Results:
2D system. Changes within tooth segments from T0 to T2 were at worst 2.0 units (ΔE in the gingival segment), which is less than the threshold of 2.7 units for a clinically meaningful difference. Confidence intervals for the treatment effect indicated no clinically important differences in color change between body and gingival segments. 3D system. Changes within tooth segments from T0 to T2 were at worst 2.3 units (ΔE in the body segment), which is less than the threshold of 2.7 units for a clinically meaningful difference. Confidence intervals for the treatment effect indicated no clinically important differences in color change between body and gingival segments. Thus, MBA treatment did not lead to clinically relevant changes in tooth color.
Conclusion:
Within the limitation of this study the MBA treatment can be seen as a safe method with respect to tooth color.
Related Concept Videos
03:02Colors and Magnetism
When atoms or molecules absorb light at the proper frequency, their electrons are excited to higher-energy orbitals. For many main group atoms and molecules, the absorbed photons are in the ultraviolet range of the electromagnetic spectrum, which cannot be detected by the human eye. For coordination compounds, the energy difference between the d orbitals often allows photons in the visible range to be absorbed and emitted, which is seen as colors by the human...
01:21Tooth Anatomy
The Crown, Neck, and Root
The visible part of the tooth is referred to as the crown. It's covered by enamel, the hardest substance in the human body. The crown is uniquely shaped for each type of tooth, allowing for different functions such as cutting, tearing, or...
01:30Assessment of Airway, Skin Color, and Use of Accessory Muscles
Introduction
The initial evaluation of a patient's respiratory system...
01:30Electronic Distance Measuring Instruments
01:24Color Vision
03:07Electron Affinity